On Jul 1, 2017, at 4:18 AM, Harold Thompson haroldthompson157@... [jmriusers] <jmriusers@...> wrote:
I have not used JMRI for several months and the only chnage to my layout since its last use is the introduction of NCE EB1 circuit breaker. Since fitting the EB1, I have been able to operate everything with my Power/Pro Cab and SB3a booster but now find that I cannot operate anything through JMRI. JMRI loads properly; there are no error codes or messages in red; I can display the panel and the roster but cannot get either the throttles or the points to work. On screen, the points change but nothing happens on the layout - equally, the throttle functions highlight and the slider works but nothing moves. Can anyone iddentify the problem and tell me how to overcome it pleas?
This sounds like a communications problem between JMRI and the layout.
How do you have them connected?
Check the JMRI preferences to make sure that they¡¯re still set to the right port, NCE settings, etc.
Bob
--
Bob Jacobsen
rgj1927@...
Bob Jacobsen