Dave,
That did the trick even though I did not change anything! I went into preferences, saw that everything was selected for NCE. I clicked X to close the window and another popped up stating there are unsaved changes, do you wish to save. I clicked save which prompted me to restart Decoderpro. Once restarted, service mode and operations mode is now green. I now can read a decoder!
Thank you again for your help.
Best regards,
Stephen
---In jmriusers@..., <dgheap@...> wrote :
Sudden memory:
Go to Preferences->Defaults and check that NCE is selected for everything, rather than Internal.
--
Dave in Australia
toggle quoted message
Show quoted text
On 22 Jun 2017, at 10:38 PM, Dave Heap <dgheap@... mailto:dgheap@...> wrote:
>
> The "nce.NceConnectionStatus INFO - NCE EPROM revision = 7.3.0" in the log below indicates your drivers, jumpers, baud rate and JMRI settings are correct and that JMRI can communicate with your NCE USB.
>
> We now need to see a log (and a report on what the NCE USB LEDs do) when you attempt to drive a loco, program a decoder).
