开云体育

IC-7000-HDMI Separtation Kit DM5AI Manual attached. I have used it for a year. Jim WI6X

Hi Larry, Those are in short supply. Neither is available from Icom any longer I do not believe. DM5AL has a separation kit he designed. I am not sure if they are still available or not. You would

I picked up a second IC7000 at the hamfest.. Rig is 9.5 of 10.. It came from an estate, and there was no box, no separation cable- control head mounting. There was a 706markII and it had the

I think I wrote something on this long enough ago that I have forgotten most of it. Do a search and see. I worked on the ALC extensively at one time, but I forget the specifics.

Thanks Steve, I was already using your measurements from your past post to troubleshoot this units operation.? ?At R1624 and Q1606, Im getting about 2.5 volts no ptt, and 1.4 with ptt, both being

Looks like I can't upload a file to the Group, so here a copy & paste of some levels I took In 2012 at a slightly different component: Set your 7K to 14.2MHz, FM Mode, 100% TX PO into a dummy load.

Has anyone recorded the proper voltages under any condition at IC1601, particularly pins 8, 9 and 10. And the area of Q1604? If so, thanks!

Here are the directions: https://www.repeaterbook.com/wiki/doku.php?id=rt_systems

I think that you can export your local repeaters from RepeaterBook on the web, You will get a file (perhaps CSV) that you can import into RT systems. It takes a little looking for the correct files

First of all i like to thank everyone for responded to my first question with a solution. Now I am trying to down load my area uhf/vhf frequencies into my ic7000 from the call book which is suppose to

The IC-7200 and IC-7000 have different addresses for the C-IV. The default for IC-7000 is 70h or hex address 70 The default for? IC-7300 is 94h or hex 94 Check the address in your radio to be

I have done this many times with my IC7000 by following the manual for the Signal Link USB and manual for WSJT-X.? First of all, I purchased the IC-7000/FT-817 jumper module SLMMOD6PM for the Signal

Helping a friend over the radio and trying to help him get WSJT-X running with his 7000 and a Signalink interface. Can someone provide me with the instructions to do this. Getting the rig error

It is the CIV jack - I have the same cable / SW. 73's - Glenn

<https://www.rtsystemsinc.com/ic-7000-communications-error-when-programming. html> IC-7000 Communications Error (rtsystemsinc.com)

If I’m not mistaken it’s the CI-V jack David P Milligan 843-615-6858

Just received the RT System program and i don,t see any where in the instructions where you plug the the cord into the back of the radio ? Can any one help this 78 year old new be ? VE3LGP

After an RF feedback event, my IC7000 has very low TX audio. The TX power meter barely moves when speaking into the microphone in SSB mode, and on FM, the deviation is only 1 kHz. The MIC Gain setting

If you can use a power supply 25A continuous or larger. The 7K is sensitive to voltage drops. 73! Mark KA6WKE Website: https://www.ka6wke.net

Clean the fuses in the power cord -- Sent from Outlook Email App for Android Sunday, 20 February 2022, 08:45AM -08:00 from giubigaz@... :