开云体育

Thanks for the confirmation Larry. yes something that runs on 12V is a must for me. Lynn WR7G

Yes, that's it Lynn. Chosen on the basis of all the commentary and the fact that it runs on 12v. Nice color picture. 73, Larry

I had one of those cheap 7" TFT video displays in a box for years and finally connected it to the IC-7000. The colors are not there, it shows up white text only. Also, it is slowly scrolling down

Thanks, Kees, I just set it to "2".? The width on the external display became slightly less wide.? It's still distorted relative to the internal display, but less so. Cheers, Halden VE7UTS

In display set mode No19, you can choose 1 or 2. You have to choose 2 because it is a 4:3 composite video signal. It works fine for me on a 7 inch monitor. (with black areas on the sides.) 73s, Kees

Larry was it a Curtis RT700 TV that you were using? Lynn WR7G

Swr check can be done with two dummy loads connected by a tee piece, to make 25 ohms. Keep the cable lengths the same especially at UHF. At UHF every 1mm is 1 degree of phase. On top band no issues

Ok, so……turns out, user error. I learned a lot and had some realizations while I was typing this email to tell you what my readings were. It left out what frequency to set the signal generator to,

There is a display adjustments: KR Andrew ?Get BlueMail for Android ?

I have and its fine, still shows 100w on all HF and 6m, just the power level on the radio drops one bar to just below 100% just a strange one, it has no affect on the output power at all Adrian

What is your fault, what is the rsfio not dooing? KR Andrew ?Get BlueMail for Android ?

Measure it with a good Watt meter, sounds like to me it is a low pass filter coil check for dry joints 73 Andrew ?Get BlueMail for Android ?

Hi Al I know this is an old thread did you ever get to the bottom of this, one of my 7000s shows something similar but only on 10m, its 100w on HF and 6m no problems at all but on 10m, the power bar

Thank you so much Andrew for jumping in. My CMU200 can set the output down low enough. How do you minimize leakage for the WFM adjustments? I am going to double check with the oscilloscope when I get

Hi I have replied a fair few of these radios, all with 100% success. With regards alignment I have never had to pefrom this on received. I have set up the bias on PA transistors after replacement,

I was planning on making a video of the process once I get the kinks worked out. I am learning and this is not an easy radio to work on, and I’m suspecting the service manual has some typos, or I am

It’s probably a setting on the monitor to allow you to hang it from above. See if there is a menu setting to flip vertical. 73 David W4OFO

Hi Stephen, Oh you were very clear.? I was just trying to be funny. It sounds like a monitor problem.? To be sure, I think you may have to try it on another monitor.? Many modern TVs offer a video

Just in case I was unclear in my initial message, the display on my IC-7000 is rightside-up. It is the display on the external monitor that is upside-down. VY 73 de W3UECSteve

Hi Stephen, Any chance your IC-7000 is an Australia or NZ model?? Maybe you'll have to use inversion boots.? :-) Halden VE7UTS