开云体育

What do you mean by "inappropriate value capacitors"? Congrats! Bob W4JFA gmail.com@groups.io> wrote:

Hi very well done 73 Andrew Sent: 12 March 2025 17:31 To: ic7000@groups.io Subject: Re: [ic7000] Fixing the unrepairable IC7000 It’s been a while since I updated, but the repair has

It’s been a while since I updated, but the repair has been a major challenge. ?Finally have a major update. ?The radio has been repaired without having to replace any boards. ?I bought a new DDS,

Take the spring out of a ball point pen, then through the pen away KR Andrew ?Get BlueMail for Android ?

In case anyone loses the springs for their display unit or they lose their kick, you can buy springs on Amazon that fit perfectly and excellent strength. Amazon link: https://a.co/d/ifI0fHg

I remember the other question I was going to look up before I answered. ?Where are the “components to check 4R7” that you were referencing? ?That confused me and I went to look at the manual to

Sorry I wasn’t ignoring you. ?I’ve had a lot going on between the radio and home. ?I lost the springs for the display retention clip and was waiting for replacements to come in before I pulled

Thanks for the non-reply of my email below. No one can answer those questions since 2/10.

Are you referencing the 2 tant caps on the display board? ?Those were the first things replaced because they were replaced before at some point with much smaller capacitors.

Ps change the two tant caps in the head they smooth the 12V rail generated by the buk converted. As the6will fail. 73 Andrew ?Get BlueMail for Android ?

Does the S meter indicate with signal, is the DSP module warm as it foes run rather hot? ?Get BlueMail for Android ?

Main board is successfully repaired! ?It powered on for the first time in years! ?No audio, so onto the DDS Board

As far as we know radio was working fine up until my grandfather crashed his Saturn. ?We suspect the crash cause a voltage spike that caused the failure. ?Can’t figure out any other source.

Oops Sorry Andrew I got the name wrong. Pat

Nice job, Craig. It sure helps having a microscope and rework station. As I passed on before, Techni-tool has traces and eyelets to repair boards. This is what I did for 35 years in the Navy and a

Hi Do you know what caused the fault in the first place? KR Andrew Sent: 17 February 2025 16:37 To: ic7000@groups.io Subject: Re: [ic7000] Fixing the unrepairable IC7000 First pic-

First pic- post repair (almost completed). ?Replaced the 2x Ferrite Beads, Resistor, Capacitor, and 2x inductors. ?White spot over the resistor to the left is glare over the flux. ?I still need to

First pic- top view of the logic board. ?Problem was the burned inductor. ?Replaced the inductor and Logic Board appears functional again. Burnt section on Main Board. ?Components actually seemed

Hi Tommy, I suspect the track overheated by someone tuning while at full power and running a hight SWR. I presume you do have full power control and can turn it down? KR Andrew Sent: