开云体育

Hi Dan, I am successfully using software modems for both HF and V/UHF and I use the 13 pin connector. I also have HSEND & VSEND (Pins 3 &7) diode or-ed together so that I can use a single key line to

I am trying to set up VARA FM with my 7000. Is it true for VHF I have to use the 6 pin data port on back and not the 13 pin port?

Just found the rotary switch on the bottom left of the faceplate (PBT/M-ch RIT) won't push in so I have limited capability to get to the memory channels. Looking to get a replacement. Will KA3UQQ

No. Its a local guy here in AZ that always comes up with gear and sells reasonably on ebay. Sent from my T-Mobile 5G Device

Are those yours, Bill? Yahoo Mail: Search, organise, conquer On Tue, 19 Mar 2024 at 20:45, Bill Kouchis<bkouchis@...> wrote:

https://www.ebay.com/sch/i.html?_dkr=1&iconV2Request=true&_blrs=recall_filtering&_ssn=salvage-1_electronics&_oac=1&_pgn=1 Sent from my T-Mobile 5G Device

Would like your IC-706 mk ll G in an exchange or part-exchange deal with my immaculate IC-7200, side handles, fitted leather case, all original accessories, large binder of manuals? reviews, mods. A

Likely its the first time you noticed this. ALC is not used for FM and AM modes its meaningless to them. Also Every 7000 I've seen and my IC7300 has the same behaviour. -- Allison

I left some info out of my post. When selecting FM or AM modes the ALC maxes out, regardless of MIC gain settings. Works as expected using SSB. Hopes this helps, Dennis ... AI6R

Hello Group, I think this is my first post here. My name is Dennis and my station call is AI6R. First off I love my Icom 7000 and I use it weekly, but just recently it started miss behaving when

A lot

James, Take your ohm meter and put it in diode mode. Test the power lead that goes into the radio for a short. Swap leads too. It's possible the short is inside the radio. 73! Mark KA6WKE -

Sounds like the finals are shorted and drawing excessive current.? I had a 706 years ago that the finals shorted and it drew a lot of current and got hot.

The Icom Service Center in St. Joseph, MI.? Matt there is exceptional, reasonably priced and quick turnaround. Yahoo Mail: Search, Organize, Conquer On Tue, Mar 12, 2024 at 2:43 PM,

Hopefully it as simy as you just popped a fuze.? Check all fuzes.? There us one on the face of the main portion of the radio behind that 1" square piece of black plastic, the two in-line fuzes, and

I own a IC 7000.? The? + 13.8 volt line touched the IC7000 ground. How much damage can this do ? I assume this has happened to others . The radio draws a lot of current and will not turn on

I sent mine directly to Icom. The service was quick and reasonably priced. Mark KC9C [email protected]> wrote:

I live in Montana. Where is a good place to send my IC 7000 in for repair ? Thanks for any recommendations. James

Thank you!!!!!! Yahoo Mail: Search, Organize, Conquer On Mon, Mar 11, 2024 at 11:20 PM, Bob KM4RL<km4rl@...> wrote: https://powerwerx.com/hf4-power-connector-cord-side

https://powerwerx.com/hf4-power-connector-cord-side