开云体育

I want to operate WSJTx with my 7000. I've connected the radio to my laptop, via a rigblaster advantage and am using Ham Radio Deluxe for rig.? control. FT8 is decoding fine. Just wondered if there

John - I've never directly programmed my IC-7000, nor have I ever used the packet data interface - so feel free to ignore this if you get more knowledgable feedback! ;-) That said, some

To me the manual is unclear as to what the actual byte code should be for a "(0=off, 1=ON)" statement. The manual states that the "Data Area is /BCD code data for frequency or memory number

Greg, and others, I have attached the relevant manual page from the IC-7000 manual; I just downloaded it from the Icom web site. The command code I see for setting / getting the bps setting is shown

Pretty sure you have your codes confused, From my 7000 manual: 0A Memory to VFO 00 Frequency data 01 Mode data And the end needs to be FD for end of data not FE And in the command listing I

yes I want to toggle the audio connection setting from 9600/1200 bps. How do I do this using a remote controller? NX2I gmail.com@groups.io> wrote:

Dave, ypur answer is not clear for me. I want to change the bps setting for packet. I am using the din 6 connector on the rear of the IC-7000. Nx2i

Hi the 1200/9600 is the audio data port not cat data, Dave 2E0DMB

I am interested in trying to control the 9600/1200 bps setting for the data connection to the IC-7000. Thus far I have tried and failed using the "send Command" option in FLRIG. Has anyone succeeded

Sorry I forgot to reply. ?Thanks I had the PSIC connects swapped. Ed

Has anyone made a selector switch to switch from a PSIC headset to the Icom mike?

The 7K's aren't much more DC voltage dependent than any other mobile HF radio, IF the poorly designed fuse holders on the factory DC power cable are replaced with good quality 30 amp holders that bite

If it's indeed low voltage and not RFI, N8XJK (and others) make a 'voltage booster' that may help. When I was a sailboat liveaboard I used one while at anchor or under sail, essentially whenever not

I had this exact problem with my 7000 as well on 40m only. Turned out to be RF in the shack. In the days before I had proper 1:1 Current BalUns in the feed coaxes. The culprit turned out to be a

Michael.....Icom radios are very voltage dependent...My 7000 will transmit with the truck shut off about two or three times for short periods, then the radio shuts down. Cut the power to 30 or 40

Nott at home, so don't have a dummy load, but will try the ferrites.

I have a. Choke on order.

I would start with some ferrite but also try a dummy load at full power. If the radio shuts down then check the fuse holders by reseating both fuses. 73 GL Feb 5, 2024 7:57:30 AM Michael Parker

Michael, This appears to be a case of RFI. Most likely coming from current traveling on the outside of your coax feedline back to the IC7000 which is causing the shutdown. The amount of "common

Anyone had this issue.? Powered by a LiPo battery and using a 1/4 vertical with a wolf river coil with an swr less than 1.5.? When transmitting CW at 100 W, the unit will shut down.? If I turn down