开云体育

David et al, As suggested by Ludovic, it's a good idea to clean the contacts of the head unit and not rush to change display. If issue persists, you might wanna try a factory reset to see it clears

Hello, it looks more like a signal fault coming to the display. It's not impossible that it's just a bad contact. In short, do not rush to change the screen. Best regards, Ludovic -

Mario...yes, I see that too.? A little bit of black screen on left side.? Not sure what that would mean.

if any one need new display for icom ic7000 .please contact me ,i had 2 new displays available for sale ....thanks

Dear David, Apart from the said color distortion, I realized that there is another problem with horizontal width scan of the display. Most discernible with the blue background, the black screen space

I have had the display apart and it can be done to clean it, but it is a little fussy as I remember. That was a good while ago, but I don't remember it being especially tricky, just keep the proper

Heat can also cause this distortion.

Wayne...yes, it does kind of look like that and I suppose it's a possibility.? ?I'm fairly comfortable taking electronics apart and putting them back together.? Not sure how difficult it would be

I have an HT with the same issue and it was caused by being bumped into with a hard surface ( seat belt buckle). Only fix for mine is a new screen. I'll live with it. You might send Icom an image of

David, In my humble?opinion, it appears that some kind of liquid ran in from the left side. Probably while it was standing on its right side. There is usually a diffuser?that is behind the LCD to

In my humble opinion, it appears that some kind of liquid ran in from the left side. Probably while it was standing on its right side. There is usually a diffuser that is behind the LCD to disperse

Thanks I will check that out. Get Outlook for iOS<https://aka.ms/o0ukef> ________________________________ Sent: Sunday, July 23, 2023 11:32:43 PM To: [email protected] <[email protected]> Subject: Re:

I have never seen this distortion before but I’m thinking it’s most likely in the actual LCD. I’m going to guess that with round trip shipping, one hour of shop time and the part, you’ll be

There is no internal fuse for the 12 volts on the tuner connector. There is a surface mounted choke on the DDS unit that’s probably burned out. Depending on how bad it is, there might be some

I just purchased an ic-7000 from HamEstate.com. Everything seems to be working fine but the screen has some kind of distortion (highlighted). It wasn’t visible on their website. ?It’s just kind

I just purchased this Icom 7000 used and connected it to my Icom AT180 tuner. It was connected to my 7300 and worked fine. No tune on 7000 so I checked for 12 volts on the tuner plug but its zero

More info would help.? Can you make any adjustments?? Are you sure you have the audio input as specified in the TX setup -- correct connections and right signal level?? Have you verified your coax

Shorting plug in the REMOTE jack? Will it go into service mode without the plug? I've never tried it. Jul 21, 2023 2:24:07 PM Andrew ZS2PA <pride01@...>:

Any ideas guys?

Repair ships will service 7000 still. I just sent one in. There are two out of warranty repair ships listed on icom website.