开云体育

CB – before you rip the rig apart… does your configuration support other digital modes (i.e. PSK, FT-8, Olivia, etc)? Are you using any sort of commercial interface between the computer and your

What connector are you feeding the audio into? The book says that the front mike is disconnected win digital. Perhaps the audio signals are not going into the proper pins? Does it work on WSJT-X? 1

Thanks for the response. I’m using CAT control and everything there works. In fact, I can hit TUNE on JS8CALL, radio goes into transmit, and will modulate my voice from the speaker mic. It’s

The problem is probably that your software isn't telling the IC-7000 to go into XMIT mode. Check the settings in JS8CALL, see how it is doing XMIT / RCV switching, and check that whatever it does on

Hi Team I have an IC-7000, transmits well with hand mic both FM and SSB. Transmits Tune tone well. When using JS8CALL, audio is not getting onto the signal, I see no power fluctuation on the

Yes, the ML920S/DN works fine.? It has the same surface mount tabs as the /F9D.? The only difference is the coin cell has an insulating wrap around it, which is fine.? The price at digikey.com is

I believe it is in the silver logic unit, left rear top of the radio. From bad memory. [email protected]> wrote:

Where is the clock battery in an IC7000?

Looking for a photo of the ML920S/F9D to see if is the same as the ML920S/DN Panasonic battery because i can but it here in Canada for $4.98 .

My understanding is: - if it is running SSB on HF, then SWR is fed to ALC and audio, and hence output, throttled back to protect the front ends. This protection is not available on AM,CW, or FM. --

By design, it is supposed to reduce output power, however... My experience has been that at high power levels, it will blow the driver transistor. To help avoid an expensive repair, reduce power to

Il réduit sa puissance en HF. 73's de Michel? F6FSC

Greetings all. If the SWR is high what does the 7000 do; eg does it shut down, reduce power what! Thanks for your replies. 73 de Geoff vk3sq

Hi guys In my case was R1124 fault, as I wrote to Steve ? In this link, in a local forum in Italy, I have described this problem. You can use google translate for english

Of course that?is not te same thing as a?DMR capable radio at least IMHO. Hank Blackstock? No trees were harmed in the creation of this message, but a large number of electrons were terribly

You would have to go through something like an open spot three. Mike

As far I know no Icom radios are DMR capable. Hank Blackstock No trees were harmed in the creation of this message, but a large number of electrons were terribly inconvenienced.

Will the ic777 work on DMR ?

No Hank Blackstock No trees were harmed in the creation of this message, but a large number of electrons were terribly inconvenienced.

Will a ic7--- work on DMR ?