开云体育

Got it figured out - thanks anyway! Paula

I am trying to set up N1MM to run RTTY using the MTTY digital engine. I am using a Signalink Interface. Do I keep the rig in USB mode like I do for other digital programs, such as HRD for PSK31?

Dear All, These are some ICs taken from other parts damaged logical unit of icom ic7000,parts are available in 2 qty of each ,This will be replacement for DSP ics damaged in the logical unit

Guess they're gone... W2CQ

I have a few surplus flat cables on Ebay Item 153810076642 In case you need them. OE8UWW

Hi, All, I'm still looking for a nice MFJ-706 or MFJ-7000 here in the UK (overseas deals would probably not be effective because of the weight). I?wrote the original review in PW and was talked into

Thanks. One more thing to try; I was thinking of hanging headset on the cable to hear whether there are any signals coming through the cable,too. Take care rom

You could connect the 7000's video o/p using a switch to the reversing camera input to the vehicle display. The switch would also put a 'dummy' reverse signal to the display unit. I did this for my

Don't forget about video out on the back if you are using the 7000 as a base unit. Any video monitor or display will work. Bob

Don't forget about video out on the back if you are using the 7000 as a base unit. Bob

If you are indeed using the CI-V port on he radio, you should probably go into the menu and UNLINK USB FROM REMOTE. Your now have two separate line of communication with the radio, using the USB as

I have a USED IC-7000, I know the display is fine and this radio may work, it does receive on all bands and acts like it wants to work.This is a radio ONLY, no mic, no power cable or mounting

At one time, you could buy a complete IC-7000 control head from Icom, but that was quite a long time ago. I believe the cost for it was over $400. I bought an IC-7000 on eBay several years ago that

Gosh, I have 2 IC7000 and 1 IC706, and my primary rig is an IC7300. None are for sale, though I am always open to offers. The 706 has the cord that goes between the controls and the body of the

Dear pasqual, I have original display for icom ic7000, if you can carry out the replacement surgery I can send across ,attached the pics here, 73s Prabhu

sorry Pasquale I can’t suggest anything but Icom, or maybe AmAzon or eBay Take care rom

Hi Ron I’m looking for a new control panel ? to buy My IC-7000 has a display failure. Regards. 73s Pasquale IW0HEX Inviato da Posta per Windows 10 Da: Ron Peak Inviato: mercoledì 12

Ftdi is just a different chipset (interface hardware) and driver (software) than prolific. Since you're using the Icom cable, it's probably not the issue, but maybe the driver from icom is not

What do you need? I have parts of the control panel for sale on Ebay, but of course it is bad and some parts have been robbed to fix one of my other radios.

Pasquale IW0HEX, How might I help you? I have an IC7000 in front of me. vy 73, Ron W5RRP [email protected]> wrote: *-- Ron Peak W5RRP CONFIDENTIALITY NOTICE: The information in this document