开云体育

This thread is screwy from the start. Not normal vernacular from a ham. My 2 cents. 73- W1JCW John Sent: Wednesday, September 26, 2018 8:58 AM To: [email protected] Subject: Re: [ic7000] Icom

Owners callsign WAS included in original posting! 73 de Mac, K2GKK/5 in OKC, OK

Why is this IC 7K bought after it is not removed from the original packaging,.....

Personally, with the new equipments which exists, i would not buy an IC7000 more than 450 $. Best regards, Ludovic - F5PBG.

i can post pic tomorrow ok

it's in the box i have not aver taken it out new in box

Hi Mike. I am looking to replace my old Kenwood 440s. How much do yo want for the ic7000. Where are you located. Thanks, Tom. AI4UZ

Can you post a photo of the radio with your call sign in the photo? Ralph KB1ZYI

I'm traveling until about October 3 and don't have access to my 7K's nor test equipment.? Will try to look into it more when I get home.? Meanwhile contact MFJ support. Steve, W3AHL

$700 to sell fast, $800 if you want to wait. For All of it. J Tregre, KD8M, on behalf of Her Imperial Majesty, Mystic, Kitty

Steve, under the "before wakeup" condition, when the cable is connected to the 993B, but disconnected from the IC-7000, Pin 1 is at 0V. Marco IU8HXM

Hi i am Mike and i am a Amateur radio operator. I had to move in to a apartment building and I tried my HT yaesu ft-60 and then I was told not to do it? I know I can do it with in my rights but I

Hi i am Mike and i am a Amateur radio operator. I had to move in to a apartment building and I tried my HT yaesu ft-60 and then I was told not to do it agen I know I can do it with in my rights but I

Marco, To determine if the tuner is pulling pin 1 low in condition B, disconnect the tuner interface cable at the radio's tuner port and measure Tuner port pin 1 to ground.? It should be 3 VDC.? If

Hi Steve, I have done a few voltage measurements on pin 1 and pin 2 (negative on chassis) under various conditions: A) 993B on and 7000 off, before waking up Pin 1: 0,03 V,? Pin 2: 1,43 V B) 993B

You might check the voltage on Tuner port pin 2 to ground (pin 4 or chassis) after you first power up the tuner and radio and then after "waking up" the tuner and power cycling the radio to verify

Hi Steve, thank you very much. I'll do as you say. 73 Marco, IU8HXM

Marco,? The 7K requires a voltage on pin 2 (Start) of the Tuner port when it is powered up to recognize that there is an AH-4 compatible tuner connected.? In the 993B tuner, the voltage that goes to

I am guessing here. Icom changed the PTT circuit at some point. The signal from the tuner to the radio needs to be a ground. In the past, it was a +12V. If you are using an older design tuner, it

Hello, I have noticed that under particular circumstances, the tune button works as expected. After many trials, I have discovered the following sequence to have that button working: - Power up the