开云体育

Hi Paul you do realise the 6 meter output and receive is on the HF port of the radio not on the VHF/UHF port. a common enough mistake to make.??????????????? Best regards robert G6LLP

Did you try to use a antenna tuner and push the tune button? that is assuming you are using a antenna tuner for HF 6 meter.

Except that 6m FM seems to be more susceptible to local electrical noise than 2m. And because of the size of antennas, etc, many don't as easily have the height/site advantages that are more common on

I've found 6m simplex to be generally equal to or better than 2m, especially in hilly areas. -- 73 de Tony VK3JED/VK3IRL http://vkradio.com

Would assume your repeater has a very good height advantage... on a mountain or hill. Mark

Sounds lilke your 7k rx has its tone ?squelch "on" (dial.shows "CT"). ?The repeater apparently has tone access only. ?It does not transmit the subaudible tone, So your 7K stays muted on the rptr.

On 11/11/13 11:17 AM, paulgibb@... wrote: > > > Hello All - > I am a new member of this group and fairly new to amateur radio. > My question involves settings I might check/change in the IC

Perhaps use a duplexer, such as a DIAMOND MX-62M, instead of switching to and from the HF and VHF/UHF connectors. -- Jim, KG4FXV ? . The 7000 uses one antenna connector for VHF/UHF, and another for

They might have set the antenna up with a duplexer to use it with both antenna ports, but the duplexer may have been zapped if it wasn't for high power. This message was delivered by flying

You raise a very good point Brian. 10-15 miles simplex on 6 meter FM would be a bit of a challenge. 6M is more line of sight than the lower frequencies. You would need a pretty good LOS path for it to

The 7000 uses one antenna connector for VHF/UHF, and another for HF (thru 54 MHz). Using a triband antenna, you must switch the triband antenna between the transceiver antenna connections when going

Are you sure this was simplex, or were you on a repeater-freq. On certain sections of the particular bands, the radio automatically becomes a half-duplex radio: different rx & tx freqs. When you key

One would assume so if he is able to get into a repeater 17 miles away. There are lots of things locally that can cause your receiver to be deaf. Many kinds of electrical interference. You may not

Tone squelch turned on? Squelch / RF gain control set wrong for 6m. This message was delivered by flying monkeys!

10 ? 15 miles on simplex? Thank you, Brian Mackey KC1MAC Hams don't let hams get stuck on 2 meter repeaters! :) From: Simon Thompson <simonthompson67@...> Reply-To: <ic7000@...>

The antenna is connected to the correct antenna connector?

Hello All - I am a new member of this group and fairly new to amateur radio. My question involves settings I might check/change in the IC 7000 to improve reception on the 52-54 MHz portion of the 6

I agree ,, if you are tired of a subject delete it when you see the heading that's what the delete button is for

Hi Everybody; I would also suggest that people at least read the following Yahoo Group to see how we are pursuing getting things changed; I personally would like to see an option for people to have a

+1 -------Message original------- De : Svenn Ole Fanakr?-Staurnes Date : 10/11/2013 18:32:53 A : Ic7000 Sujet : Re: [IC-7000] Re: IC7000 Internal Clock Problem Can everybody stop beeing so sarcastic?