开云体育

Al: I have had the same problem with HF (3.856) and the reset also works there. Did you try HF yourself and if so, did you have a problem? I will add, my problem only occurred about once every week or

There is no way to turn it off. It is a faulty. Did you check RF power? Is it over 10 or more watts? Is there any indication in SWR? Hi swr ?? nothing ?? Is there power out indication? _____ From:

Some great suggestions. However, I originally applied 3M VHB Auto Body Molding Tape and it didn't stick very well at all.....I used Rubbing Alcohol on the dash before application but now I'm thinking

The product to use is 3M VHB. That is what ships with most mounts for this type of application. Amazon has some smaller rolls but the larger stuff can be very expensive especially when you only need a

My wife is a sign maker and I used the double sided tape she uses to fix signs onto stuff. Find a local sign shop and see if you can scrounge 6".

The double sided tape used to hold rear view mirrors directly on to the glass seems to work well. I have a small monitor on my dash top using this tape. It has been there for three years now. Quite

I just replaced my Mobile vehicle from a 2000 Ford F250 to a 2012 FORD F350. Went through all the right moves to set up my IC-7000 from one truck to the other.... Problem being I had to use a Hair

... on mine, it is... I do some test with OM at 3 kHz from my frequency and they don't hear me. So IMD are not present otherwise I'd be scolded... ;-) There is something not clear on my IC7000 but it

I don't dispute what you are saying (other than "the ALC display is wrong"), but what you are doing does NOT measure the problem with many modern radios' ALC circuit. You are measuring a static level

Thanks very much everyone for your replies. I've got to wait until after Christmas before I can get time to work on it, but I will have a good look. I have access to all the gear, test sets, spectrum

I have succeeded to connect the IC-7000 to my Desktop PC, and then using the ICOM RC-BA1 remote control software as a server; I can, coming in through the Internet with my Laptop and using the RS-BA1

I reapet again : - Signal good on the scoop (dual tone sig) - Iddle current good - No IMD - 100 watts - Fine modulation by the OM reports - More than 4000 operating hours So ALC display is wrong...

Steve, Very useful data. Thank you for collecting it and putting it on the reflector. Nick N?LP

Hello, Has anyone tried to install the electret capsule Panasonic WM-61A or WM-61B on the HM-151 as described by PE1PWF on Mods.DK? Regards John

Yes, the ALC indicator does tend to go to full scale and into the red zone with compression on, but that doesn't mean it isn't creating splatter. Here is what I see on an Agilent 8924C analyzer hooked

Is it any wonder so many people blow up their radios and wonder why? But they will worry ad nauseam about how warm their radio is to touch. Mark

I had a 7K on the bench for a minor repair and measured the IC960-1 voltage with a 25 ohm load (two dummy loads in parallel) at 14.3MHz with 50 watts TX PO setting. It was 1.16 VDC and the SWR meter

Okay Captain, The ALC indicator is only meaningful when the speech processing (compression) is off, then ALC is adjusted with microphone gain. Power setting changes should have not affect. Follow the

No limit of the power... I read 100W. No SWR too... Alignment realize and same result... So 4000 operating hours, no problem and i suppose ALC info is wrong. I have not this "problem" with Yaesu

No, any splatter... Wrong ALC info sure... Best regards.