开云体育

Forgot about the switch. Oh well. Larry KF5MLP

There's a switch on the back of the control head that selects either phones or speaker for the jack on the head. -Tom, W3TLN

Last night, December 11th. I also heard a pop and smelled an electrical odor. No TX. I called an Icom service center this morning. They told me the driver transistor probably went out. I purchased

Or put the switch to speaker on the back of the head unit. =8-)

The plug on the side of the head is for a head phone. You need to plug the speaker into the back of the RF deck in the trunk. Larry KF5MLP

What type/kind of antenna is everyone using? ---------------------------------- 121013 Should have gone Mac ages ago!

Is the switch on the back of the head set to speaker or headpbones

Do you have the switch on the back of the head unit set to speaker or to headphones? I suspect the latter. =8-)

The IC-7000 is still new to me, having just installed it in my car last night. So, I have not had a chance to memorize all its capabilities and buttons (yet). Last night, when I installed my 7000, I

The reason I stressed a dummy load is that your ALC and power out will depend on the load you put on it. If you use the tuner to get 1:1, you should be pretty good. Yes, you should have a good dummy

I reckon my next investment ought to be a dummy load as i havent aquired one of thosee yet. I suppose it would be OK to find a free freqency no one's using and experiment there as that is the only

This is where my radio is, note he is stating a 7 week turnaround. http://www.angelfire.com/biz2/mts/

That may be considered the "old" way of doing it, but yes. There's no reason to turn the power down on the radio IF you are sure you have a good clean audio feed to it. Just turn the audio down. If

So basically what your saying is that I'm supposed to be running the radio at 100% power (100W) and to control the power level

I'd also second Andy's recommendation on the LDG 200 Pro II. Both of the pro versions have the SWR & PWR Meters and support the connection of two antennas. I picked up the 200 instead of the 100

Hello I can just add Iv got the next one up the LDG 200 Pro II I had read a lot about ATUs before I took the plunge from all I read it was no way going to be a ICOM on reason of price and actual

I should have said I communicated digitally by text (or whatever the proper wording is), I didnt actually talk.

Thanks for that info. I saw something on line where they were talking about a resistor. I googled icom 7000 driver stage oscillation and some info there. As of now I will use another rig. Could you

Same for me. Radio was powered on and idle the first of November. Scott at MTS Tech services suspected ICOM has the bias on the driver set above manufacturers spec. Note that is not confirmed yet. My

I too have the same setup. Excellent combination! Dave KI4ROL