开云体育

Did you mean the mic, the earphones or both? I have the same adapter with a Koss SB-45 and it works in front at least. I don't think I've tried the read mic connector. The mic and footswitch

Hi Ed, Have you tried disconnecting the footswitch from the AD-1-iCM to see if that makes a difference? Have you also tried moving the AD-1-iCM to the front mic connector? -Brian, KB3ORR

I just bought these items and when I plug the adapter in to the back of the rig, the mike is already hot and the headset doesn't work. ?I have a foot switch attached. ?Any help would be

ON VHF irrespective of power? output The radio draws 12A of current on tx It txs fine audio out fine? but obv heats up fast Any ideas i checked adj mode its all set ok

Thanks, Steve I think I have some RFI problems.

Thank you Steve that explains alot!Thank you.

I had this happen several times many years ago, but don't have any notes on what I did to correct it.? I vaguely remember it being a problem with not having the HF antenna coax connector shell fully

Andrew,? You don't specify which voltages appear on which leads of Q101.? I don't have my 7K and test equipment with me at my current location, but you should see the collector be about 13.8 VDC in

Sometimes after I send CW, the transmitter will go into transmit (tx light on) and stay on even though I have quit sending.? If i push the power button it will stop transmitting,? I am not turning

Steve what should the voltage be on ic Q101 I am getting 0.751 aand 13.8 is this correct (whilst i transmit) 0 volts and 13.8 volts when i do not transmit!

Maybe there is an issue with how the scope is set up?? The probe's slide switch should be on 10X and the Channel Menu for Probe should be 10X also.? Maybe the trigger level is set too low or the

Yes it goes into tx. believe it or not i can trigger a local repeater even with no output! Strange hey! I will look at the mainboard.

Thanks for sharing your situation.? I looked at your info on QRZ and you have a nice station.? The IC-7000 isn't easy to troubleshoot! Your latest J101 IF measurements looks like the unit isn't

Ment to add i am disabled on the complete right hand side and have very litteled electronic imformation.

The voltages are as follows: J101 Coax from Main IF !.840 cw 3.80mV 3.788 cw 3.20mV 7.100 cw 2.8mV 14.200 cw 3.4mV 28.400 cw 3.0mV 146.00 cw is 3.2 mV I think there is something wrongHere!

Here's the manual for the probe that shipped with that model: https://beyondmeasure.rigoltech.com/acton/attachment/1579/f-06be/1/-/-/-/-/PVP2150%20User%27s%20Guide.pdf On page 4 is the parts list.?

Hi i am using a Rigol ds1104b with the probe hope that helps. i can see each ptest the voltage jumps!

None of the voltages you measured are close to what I normally see.? The first set of levels from the IF should vary with frequency, but yours don't.? They look like just noise levels.? What

The voltages are as follows: J101 Coax from Main IF !.840 cw 136mV 3.788 cw 144mV 7.100 cw 152mV 14.200 cw 160mV 28.400 cw 128mV 146.00 cw is 168 mV Driver Input J101 to J103 !.840 cw 184mV 3.788 cw

Sorry Steve I cannot adjust the output via the service menu. it is very strange!