开云体育

Hi try putting a 50ohm dummy load on the radio and see if it still is happening, if it is not it is RF getting back into the radio, Try a common mode choke on the coax at the antenna and if you still

Hi everyone, i am having the same problem with my icom *706mk2g*. The problem of the audio emitted by the speaker in TX occurs on all bands, mainly in AM and a little in SSB, and grows by increasing

Using the world-famous "trial and error" method,? I have a work-around to enable loading into different memory banks on the IC-7K. Because it's free don't expect much... Here are some steps to load

OK, Bill, you can't go wrong by just _reading_ a bank via CHIRP, right? IF you get the goodies OK, then switch to another bank and read it again. And see if you get correct but different clues.... IF

Hi, Bill! Have you actually tried it? Did you read the modest suggestions? CHIRP only has to deal with just one bank at a time.... Good Luck! Gene? :)

I just looked at the information at Chirp.Danplanet.com, and it says that Chirp does not support the Bank Index and Bank Names, but it does support Bank. I am not sure what that is really telling

Gee, rarely talk to folks in typhoon zones, but I can't even spell GPS....! Funny you should mention it, but I was planning to update my IC7K soon with some needed changes. When I asked my fuzzy

At one point, chirp did not support multiple banks for the 7000. I am not sure that feature has been added. Bill Would you believe? Sent from my shoe phone's big brother and still no keyboard.

here's another way to ask the same question... How do i add to memory bank B using chirp on the ic-7000? NX2I

Is there a way to select different memory banks? in Chirp for the IC-7000? I cannot select bank B, for example, for memories that were added to bank A. 73, John, NX2I

Pin 3 of the ACC Socket (13 pin DIN). To: [email protected] Sent: Wednesday, November 30, 2022 2:27:46 PM Subject: Re: [ic7000] PTT outlet and CI-V control Where is the port for the send signal

If I remember correctly it is on one of the DIN plugs ACCY 13 pin plug pin 3 (HF)(Page 12 of your manual) . Page 21 of your manual shows the hook up to a non-ICOM linear amp. You may need an external

Where is the port for the send signal to the linear on the rear of the IC7000?

Could you use the send signal from the radio that would key a linear to control the SDR switch? It might work quicker than the C-IV.

Can the CI-V control outlet on the rear be used as a PTT outlet to control a MFJ-1708 SDR switch?

This morning, my IC7000 started producing a very loud "scratchy" noise when in RX.? It is not RF since it will produce the noise with the antenna disconnected, band and mode don't affect the noise.?

*UPDATE* : I changed the display?but this didn't fix the problem, also I removed and cleaned the cpu, also tried the red cap in the screen module with similar result, display still showing not

Hi guys wen my ic 7000 is in service mode i cannot adjust the power settings. ever had this before?

I apologize - i was out of town. Sent you another email. KD8M 85635.

Great job, Tony! I think that measuring the signal path is really the only way to really repair almost anything. I have found that sometimes these radios do have bad connections, from the ribbon