开云体育

I have done this many times with my IC7000 by following the manual for the Signal Link USB and manual for WSJT-X.? First of all, I purchased the IC-7000/FT-817 jumper module SLMMOD6PM for the Signal

Helping a friend over the radio and trying to help him get WSJT-X running with his 7000 and a Signalink interface. Can someone provide me with the instructions to do this. Getting the rig error

It is the CIV jack - I have the same cable / SW. 73's - Glenn

<https://www.rtsystemsinc.com/ic-7000-communications-error-when-programming. html> IC-7000 Communications Error (rtsystemsinc.com)

If I’m not mistaken it’s the CI-V jack David P Milligan 843-615-6858

Just received the RT System program and i don,t see any where in the instructions where you plug the the cord into the back of the radio ? Can any one help this 78 year old new be ? VE3LGP

After an RF feedback event, my IC7000 has very low TX audio. The TX power meter barely moves when speaking into the microphone in SSB mode, and on FM, the deviation is only 1 kHz. The MIC Gain setting

If you can use a power supply 25A continuous or larger. The 7K is sensitive to voltage drops. 73! Mark KA6WKE Website: https://www.ka6wke.net

Clean the fuses in the power cord -- Sent from Outlook Email App for Android Sunday, 20 February 2022, 08:45AM -08:00 from giubigaz@... :

Hi Giuliano Do you have this issue in all bands (HF/50/VHF/UHF) or not ? It’s important to know because if this trouble happens in all bands, I suppose that you are a fault in driver mosfet

Hello everyone I have a problem with my Ic 7000 this is it, the problem is on the TX part, it usually works regularly but suddenly it happens that the power drops considerably, for example it goes

Very true on the chip set troubles. This 1 is FTDI and works great for HRD to connect to radio and control the rig. I already downloaded the software but it is useless without the cable from RT

That's probably best, and Chirp may work for you using the rt cable. Some usb/rs232 cables used a cloned chip set that is not compatible with current drivers, and windows hates old drivers. Usb

Been thru all of that. Was able to read radio 1 time out of 50 tries. Edited my file to add some stuff an now cannot write back to radio. Wife spent the 50$ to buy the RT Systems software and cable.

I haven't tried this but, (I love advise that starts this way. :) ) Have you tried saving one or two frequencies to the ic-7000 memory and then uploading to Chirp? It is also possible that you have

Hello All, Anyone happen to have a IC-7000 file that was done with CHIRP software. Trying to setup some memory channels in my 7K and CHIRP will not save the empty memory files to my pc so I can edit

hello Gang, Here are my new Acrylic Call Sign Displays, with Dual LED Zones and ICOM CI-V Bluetooth hubs or Yaesu FT8X7 Bluetooth interfaces. Drop-in to WWW.VE2DX.COM or contact me at ve2dx@... if

Page 38….

I have a new amplifier and need to run <12 watts so will need to reduce my output power on a continuous basis. Is thi sage for the IC7000?

Thanks to all, I understand now 73 and Kind Regards, Marius Lubbe - Cape Town, South Africa