开云体育

Fault Resolved..... Ok, I traced the missing amplification between the generated signal and the driver to bad bias on Q101 in the pre-driver stage, Q102 was behaving normally, Q101 was attenuating,

Thanks, I've been in touch with Dave, unfortunately the rig has sold. Thanks and 73

Hi David Miller, I have a purchaser. His name is Dave Doran. He is copied on this email. Please reach out to him: davethesoundman@... <mailto:davethesoundman@...>

Sent you an email couple of days ago re offering $825 shipped to Fl.33319 paypal ppayment Rupert

Shipping to Florida? Thank you de AI4HO TIM

My mine also ran warm to hot but found an external fan on eBay and never had an issue for over eight years. TonyKH6TG

I have a ic 7000 remote kit for sale?Sealed in orginal boxNerve unboxed?I would like? 175$? plus shipping?Naturally? no extra charge if picked up.I am just south of Portland by i5.Ka7qqvDon

Here's a thought. When Icom, or any other manufacturer, find a design fault in their equipment. They repair all under warranty and make changes to the design in the next production run. They never

hi alI, I have decided to sell my ic 7000.? It is in good shape and have a new hm 151 to go with it...? manual, remote cord and grounding screew, mounting braclet and asorted plugs and screws that

Hi Curt, like you I also bought my 7000 new many years ago. At the time it was one of the first to hit the shores of Australia. I have had a few problems crop up over the years but most I would say

I've always felt that mine ran hot, but didn't really have anything to compare to. An external fan helped a lot. Max KG4PID

I bought my IC-7000 new 14 years ago and it always amazes me, but it has always had a heat issue.? I've always felt the need for an external fan. Without the fan, after receiving for a couple hours,

Hi JD.... Signal levels traced with a test set's spectrum analyser, all looks good until it hits the driver board, good level in, next to nothing out.... Regards - Tony Eagling Vk7YBG

Did I miss the signal levels measured with an O'scope? Signal tracing with the 'scope should let you see which stages have gain and where it stops.

Shall do, Thanks Pasquale :-) Regards - Tony Eagling Vk7YBG

Thanks for that, I did look at Peters videos but may have missed one. Regards - Tony Eagling Vk7YBG

Try to check if your are RF signal on Driver PCB in input, then check if your are DC bias on the PD55015 Gate, there is a resistor 1 ohm on gate, check it !!!Regard, 73 Pasquale IW0HEX

Hi Tony Have look at YouTube TRX LAB , I think Peter had the same issue in one of his videos, Dave 2E0DMB

Good Morning All.... I have a weird one on the bench, when I have had IC7000's with no output on any band it has always been an input/output feed or driver board issue. The unit I am working on has RF

Mr. Pasquale, Thank you I will try this weekend . Al Mesa