开云体育

What's the problem.. CAT Control or Soundcard issues ? ---In ic7000@..., <wally_m52@...> wrote: Is anyone doing this successfully? I have been trying to set it up with no luck, but posts

Du you have CAT- or soundcard problem ? Im not familiar with your interface ( have a microkeyer) but it should work with the same setting... Confirm you have set the right radio is in the winmor

I dont know what kind of problem you have... Is it a CAT interface or on the soundcard side (can you receive/transmitt) problem My setup worked from day one... ---In ic7000@...,

Is anyone doing this successfully? I have been trying to set it up with no luck, but posts in the Navigator group indicate the Navigator does work with WINMOR. I suspect my issue is with the way I

I just use a more old school solution - IMAP (POP works as well). :) -- 73 de Tony VK3JED/VK3IRL http://vkradio.com

I guess that explains why I haven't seen them. :-) There are certainly other annoying things about Yahoo neo, especially speaking as a owner of another list. Mark

HI Everybody; I have found a way to block the annoying ads on the Yahoo site altogether, but it only works if you use Firefox. I recommend that everybody upgrades to Firefox anyways. There is an add

I do find that fact annoying, because the V2000 is a batter antenna on 6m than the HF wire, at least for "local" repeaters. No idea which is better for DX yet. It would have been nice if there was

A friend of mines had rx problems, and then "discovered" he had the ATT inserted. It does it unintentionally by doing a "Tuning" with the external ATU, and pushing unadvertitely also the ATT/Preamp

I will check this out. Thanks. Paul G 860-459-6801 Sent: Sunday, November 10, 2013 8:08 PM To: ic7000@... Subject: Re: [IC-7000] Reception on 6 meters Tone squelch turned on? Squelch / RF

One of the stations involved in our test was using an LDG IT-100 tuner on 6 meters. The newly installed station was not using a tuner. Paul G KB1TOR Sent: Sunday, November 10, 2013 11:41 PM To:

We were using a comet CF-530 duplexer and transmitting with 100 watts. Paul G 860-459-6801 Sent: Sunday, November 10, 2013 8:57 PM To: ic7000@... Subject: Re: [IC-7000] Reception on 6

We tested on a repeater frequency, where the TX frequency dropped by 1 MHz from the repeater output frequency. We also tested on a simplex frequency 53.020 where there was no offset. Paul G

We did a drill and were able to make numerous contacts on 6m simplex in that range. There were many contacts of less than 10-15 miles but the “control” stations, which are located in higher

We are using a Comet CF-530 duplexer to connect to the antenna ports – no switching needed, it happens automatically. Paul G 860-459-6801 Sent: Sunday, November 10, 2013 8:40 PM To:

Thanks, Mark. Paul G 860-459-6801 Sent: Sunday, November 10, 2013 8:24 PM To: ic7000@... Subject: Re: [IC-7000] Reception on 6 meters

Yes it is. We are using a duplexer (Comet CF-530) that connects to both antenna ports. Paul G 860-459-6801 Sent: Sunday, November 10, 2013 7:31 PM To: ic7000@... Subject: Re: [IC-7000]

I don't know why you'd catch flack for it. Here's a link to a manual for the AT-250. http://www.coutant.org/at250/at250manual.pdf http://www.coutant.org/at250/at250manual.pdf As far as I can remember,

I realize I'm going to draw all kinds of flack for this one but does anyone no where I might obtain an interface cable to enable using a Kenwood AT-250 tuner on a 7K? Scematis that I might build my

You may also use a diplexer like the ones of Comet. They have two inputs: hf and 6m, and v-uhf (144 & 432). These shall be connected to the two rigs output; and the diplexer output connector goes to