Hi
the situation is very hard !
On solder side I think there is an opportunity but I have no idea
with the damage in other side !
You should to clean the other side well and to do some other
photos to understand if there is a space to fix ! If the area is
full of SMDs component, it's very hard to fix, the situation is
very very difficult.
Please, if you can of course, try to do other photos of other
side (side with coil) ; before clean well . Thanks
73s Pasquale IW0HEX
Il 16/09/2024 15:05, Reg Du Toit ha
scritto:
toggle quoted message
Show quoted text
Hi Pasquale
Here are the photos
73, Reg
On 15-09-2024 11:15, Pasquale S via
groups.io wrote:
Hi Reg
so you are fault in VHF section, I'm studying the schematics
!
Please, put here a photo with the burnt area so we can
support you with any idea to fix the PCB. In the past I fixed
some PCBs with burnt, often it's no possibile but sometimes
can you do it.
73s, Pasquale IW0HEX
Il 15/09/2024 08:14, Reg Du Toit ha
scritto:
Hi Paul
Just thinking, I would even consider a faulty board as
long as its not burnt up. Mine burnt at the junction of Q501
and L531. There was a dry joint on L531 and it burnt a hole
in the board. I would be able to get a working board out of
the two of them. Just hoping
Many thanks, Reg
