Helen --
You probably know more than I do, so take this FWIW --
. . . Have you done a "reset to factory defaults"?
That has cured a multitude of problems, on a multitude of rigs.
. ? ? ? ? ? ? ? ?Charles VA7CPC
PS -- and forgive me if you've answered the question in a previous post.
?
---In ic7000@..., <helen_3ry@...> wrote:
Hi Robert
Thank you for your reply. Yes it does seem that it can't be the dac as it provides the other modes.? I also notice that this radio has those ribbons as well, they make me shudder as I have had some trouble with those in other equipment. I have retired out of? radio a few years ago and I have not worked much with SMD. Is there in techniques or tools that may be appropriate? Of course I have used an iron on SMD boards but not on any thing that I have overly worried about the outcome !
Regards Helen
VK3RY
On Monday, 25 November 2013 8:23 PM, BT Yahoo!?2013 <robert.farey@...> wrote:
?
HI Helen
?????????????? many of these problems coming to light are as a result of the lead free solder used in the construction of these modern transceivers. so a dry joint is the most likely cause of a lot of problems with the Icom Ic7000.
???????????????????????????????????????????????????????????????????????? Best Regards Robert G6LLP
From: "helen_3ry@..." <helen_3ry@...>
To: ic7000@...
Sent: Saturday, 23 November 2013, 11:30
Subject: [IC-7000] Hi I am new to this group I have problems with no ssb on tx
?
Hi I am new to this group my name is Helen Vk3ry
I have lost SSB upper and lower on my rig.
I have been able to track the lack of TX down to the 1st IF?
my thoughts it may be the processor, the rig is quite happy on am fm Rtty
and good on ex. it implies the Dac is ok too,alc indicates very high alc although there is no alc voltage.
I sure I am not the only one with this prob? ? ? ??
Any one with similar experience?
KInd regards Helen VK3RY
лл
