If you scroll down that link and see the pictures of an opened wand, there is an LC at the tip connections. Not sure the values.

On Fri, Mar 22, 2019 at 10:39 AM Lee Studley via Groups.Io <indigoredster=[email protected]> wrote:

On Fri, Mar 22, 2019 at 10:33 AM indigoredster <indigoredster@...> wrote:

I just verified I could test mine with paperclip as the outer coax jumper, and a arduino type jumper with the plastic rounded using an exacto

blade to fit in the center contact, that I was able to warm up a tip and get a green light.

On Fri, Mar 22, 2019 at 10:24 AM indigoredster <indigoredster@...> wrote:

Pretty much need a handle and tip to test. However, you might be able to wire just a tip with a diy socket of hobby?

brass or an Arduino type wire jumper and outer clips. It's at RF frequencies so not a long turm hookup,?

but a go-nogo test.

On Thu, Mar 21, 2019 at 7:25 PM Dave <theschemer@...> wrote:

@Harvey,

?? I picked up an older PS2E-01 from ebay without a soldering pencil and
it was listed as "tested-good".? I got the unit and both lights appear
to be on when powered up. Is that all it takes to be tested or do I need
an iron to be sure it works? I missed out on a soldering pencil as I was
sick and had a rough day with other stuff that day and missed the
bidding. Also, are the new pencils from China any good or are they to be
avoided?

Thanks,

Dave

p.s All my carbide drills arrived along with other goodies that I have
been waiting on. :) Hopefully I got the best sizes.