Ha! All this stuff is so great I feel like I'm ready for my doctoral exam. I just missed the dingle arm thing but now it's ok.
Now serirously Doug, thanks for the mosweb page though, I think I have gathered enough information lately to introduce the TWG to all the laymen at my school. Keep preaching guys, keep preaching.
Original message :
A special tool is required to remove the dingle arm. This is
because it's buried under the lower udatulator plate. This tool,
which was Hammon part # B2-02T564, consisted of a stratifed pentagrid
plate modulator that would maintain the algebraic relationship of the
generator coil flux to the magnetic field set up by the nofer
trunnions. With this relationship maintained, the dingle arm can be
withdrawn through the fennel orifice with out fear of excessive skor
motion.
Good News--I found the dingle arm under the plate just as you said
and I bent it slightly while playing a C AUG chord on the upper
manual with all the drawbars out--I could hear the growl increase as
I bent it--I stopped at exactly 15 degrees 30 minutes as measured
with a laser refractor doo-hickey otoscope. This is the optimum
setting for just enough growl and mininum distortion. Be aware that
bending to far will raise the emitter levels of the two torsional
bias transistors to a dangerous level and could result in a complete
meltdown. As with any modification--"your results will vary"
