开云体育

Hello list members, ??? I will be connecting an A100 to a 145 type Leslie. I think the Leslie is actually a 245. Can you tell me what kind of kits are available?? I figure I could use one of the G

*LESLIE echo control type 3M* *(2)* *20* LESLIE TYPE 3M LESLIE CONTROL BOX FOR USE IN ECHO CONTROL WHEN HOOKING A 122 TYPE LESLIE TO A HAMMOND SPINET. SEE HAMMOND WIKI. IN GOOD CONDITION. *LESLIE

I forgot to mention, in the case of rubber covered cables the Vulcanization breaks down. https://matmatch.com/learn/process/vulcanization-of-rubber and https://en.wikipedia.org/wiki/Plastomer Don

It is possible the Plastomer is breaking down which will also cause the stickiness as the material degrades. If this is the case, clean-up will be temporary. I’ve only ever seen this happen with old

Thanks to you all! As this combo has been sitting in a living room for all of it's previous life, I don't think that there's gaffa tape residue, but don't know for sure, of course. The stickyness

That sounds to me like at some point, someone used duct tape to tape the cable to the floor -- duct tape (especially cheap duct tape) can leave some really sticky stuff. The way more expensive

This organ and Leslie are still available if anyone is interested please contact me. -- Steve Mason

Probably due to the environment that the cable has been previously kept or used in. Perhaps the organ and Leslie were in a room where the floor was regularly mopped, and the stickiness is detergent

You may try talcum powder.

Taped!

I'll bet it was once tapped to the floor.? Googone should do the trick.

Hello, together with a TR-200 organ and a Danish 760 Leslie I acquired the related nine conductor cable. Sadly, the cable's surface feels uglily sticky. How do I get rid of this stickyness, and how do

TK U Chris,?This gives me starting point though I have no idea what I'm doing. Do you think it might have something to do with the Reverb unit. This is where I have my Auto Vari 64 coming from. I

The fact that the noise is coming out of the lower right speaker would give someone with knowledge of the signal routing, an idea of where in the organ the noise originates. If I recall, you've told

Would love to hear it with the 147. But I don't have one. Got the pedals sounding right with adjusting the turn screw in the back of the console. Did notice the lower C spindle was a little worn. As I

This sounds like a connection issue somewhere.? ?Depending on where the organ has been sitting, the environmental conditions may have negatively impacted the systems.My comment about the schematics

If I had the schematics, I couldn't interpret them. Keep plundering along and hoping to get lucky. All of a sudden the leslie quit. Was spinning but no sound. Then out of no where it started working.

Yes the gaps will come between E&F and B&C across the two octaves. -- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus

Hi, yesterday I noted per chance that the virtually missing rods are at identical positions at both units. So I started to count: Actually, no rod is missing at all! All 25 rods are present in any

Hi Gail ......bigger than Gail Sayers? Well you're on the opposite side of the continent ...on the 42nd parallel ...I'm on the 49th.My family/parents were musicians which had me start piano at age