开云体育

A cap across the switch contacts, anywhere in the circuit. There should be one inside the 147 at the relay but it may have failed. 0.1 is standard but 0.047 would work.

I heard the Zombies in Salt Lake City last year, opening for Brian Wilson. They were excellent, and the keyboard playing was an inspiration. Best wishes, Jack Lyon

I hooked up a keyboard to the A100 to play thru the organ. I now get a popping when switching the Leslie 147. Un-hook and no noise, it has been 30 years since I have had that problem and I forgot what

from a 2014 performance by the Zombies at San Francisco's Stern Grove Festival. As much as this song is a bit of a relic, that Hammond sounds as relevant as ever. :) https://youtu.be/5ZxP1Gt5Lio?t=814

Gday folks, I've got a customer with a hammond elegante with problems.. the top manual presets aren't all working - the reverse keys check out ok continuity wise, but only about three of them work, &

Hello, I have a hammond autovari 64 drum computer sitting on top of the hammond b200 organ. recently the orange switch with which you can turn on or of the autovari option broke off. I can’t seem to

As Scott points out, such a layout diagram doesn't exist unless someone has drawn it themselves. The reason a layout diagram for the AO-28 is so handy is because it's a complex circuit with parts and

I should have also said: drawing your own layout part by part will also help you verify that the parts are correct when you compare to the schematic. Rich Reid 208-861-9263 Sent: Wednesday, June 17,

I think you will need to draw your own. Pictures are really good but taking the time and physically writing it out will also help you remember and understand.You might even take a veideo when you are

It doesn't exist! Another reason to make your own drawing as I suggested earlier. Are you afraid that the amp had previously been mis-wired? "Death caps" refers to a very specific set of caps on the

Thank you for all the suggestions. I am taking pictures for a record, but what I am after is a pictorial wiring diagram showing the physical location of all components like the one for the AO28 in my

To each his own, but prefer to make a detailed drawing. I can then label things that I might forget (like, nearly everything), and with a photo, it isn't always clear to me where things go, especially

Excellent idea. I do that more and more often. I also sometimes take a short video when disassembling a unit. My memory just is not what it used to be. rich reid -- rich reid video services boise, id

If you haven't already stripped the amp out you could take a photo of the amp underside with your phone. I do this just about every time I have to remove or disconnect wires and/or components on gear

Hi All I am rebuilding my Leslie 251 amplifier Does anyone happen to have a component layout diagram (not circuit diagram or schematic I have that) for the Leslie 251 amp? I can work out where

I have an M3 (ser: 91239, c. 1958) and an M-101 (ser: 62537, c. 1966) that need new homes ASAP. Good home more important than price! Both never gigged. Both working. On M-101, the 2nd B flat above

Thanks guys for the input.? That amplifiedparts.com site is really helpful.? Anyway I finally got a chance to measure the coils, and got DCR readings of about 60 ohms input, 175 ohms output.?

There would always be a certain amount of signal loss when mixing the two signals together. Depending on how much volume you want, you may be able to compensate by turning the volume up on the Leslie

Thanks for all the help. I was sure it could be done, but I doubt the end results would be pleasing to me. Jim Mc. Get Outlook for Android<https://aka.ms/ghei36> ________________________________ Sent:

Not on wikipedia, but searching my hard drive, I found this, -- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus