Ouch, Chris!! I said a "little", mate! With that setup, I'd better put zippers around the driver frames! but, no 12BH7, here. This is that little, stinky reverb designed by Packard-Bell. Uses a 6GW8 and carries it's own 6X4 power supply. Handy for the pre-amp.
Raul
toggle quoted message
Show quoted text
----- Original Message -----
From: Chris Clifton
To: hammond_zone@...
Sent: Friday, February 22, 2002 2:35 AM
Subject: Re: [hammond_zone] Dirt at lower leves WAS Re: BV question
If you want real good diode/class B distortion, get an L-100 and disconnect
the choke from the anode of the 12BH7 in the reverb drive circuit. With no
anode load the grid and cathode of the 12BH7 act as a diode across the
signal path, much distortion!!!!
From the Weyr and from the Bowl,
Bronze and brown and blue and green,
Rise the dragonmen of Pern,
Aloft on wing, seen, then unseen.
Chris 50 & Laura 17, Sam(uel)15 and Emily 11 in Llanelli
----- Original Message -----
From: "t402_owner" <t402_owner@...>
To: <hammond_zone@...>
Sent: Friday, February 22, 2002 9:29 AM
Subject: [hammond_zone] Dirt at lower leves WAS Re: BV question
