Re: Coax to connect between exciter and SB-200
|
Phase angle.??
If the coax length does not matter, phasing lines would not work.?
Jim, If a 50 ohm coax is NOT terminated into a 50R - j0 load, the impedance will change with length. Somewhat like using a 1/4 wave 75 ohm coax to match/change impedance of
certain antennas. Now some will say that the impedance will change but the SWR does/should not. I have a little write up from a feed line expert
explaining why the SWR does indeed change, just like your 3 foot to 6 foot example changed the SWR.
Personally I've noticed this change more so on ten meters than lower bands. Makes sense because for example a 3 foot piece of coax is a larger percentage of a wabvelength
on ten meters than on the lower bands.
Bob? W4JFA
On Sun, Oct 29, 2023 at 2:43?AM Jim VE7RF < jim.thom@...> wrote:
toggle quoted message
Show quoted text
Watch out with length of coax between xcvr + input of the amp.? ? On all 4 of my Drake L4B amps, if coax is 3' long, input swr is flat on all bands.? ?But when I use a 6' jumper, input swr increases to aprx? 1.4:1? or? 1.5:1? ? and no amount of slug tuning
will reduce it.? And the Q of the tuned input PI networks on the drake amps is a helluva lot higher? vs a SB-220.? (cap values are higher)
?
On my big hb amps, they all use a manually tuned, PI tuned input.? Same deal, but at least I can tune it dead flat.?
?
I still have not figured out why the interconnecting coax length affects? input swr.?
?
Jim? ?VE7RF
|
