Mark,
?
It looks like the two systems are connected ok.? You might verify that by using the M command from the XNET virtual machine console.? This just sends a message across the CTC to the other side, and the message should show up on the other side's XNET virtual machine console.? Use the M command like you would if you were on CMS using the M command (the MSG command).? Specify:
?
M nodename MESSAGE_TEXT HERE
?
So in your case, from the VM370DEV XNET console, type in:
m VM370-01 This is a test.
?
On the VM370-01 XNET console you should see:
@VM370DEV This is a test.
?
You should also be able to send it the other direction as well.? If you are not receiving a test message then this would be why the 3270s are not connecting.? If the message does go through ok, then there is probably something else wrong.? Can you paste your XNET CONFIG file (from both sides) for reference??
?
Depending on your results, I may ask you later to obtain some diagnostic information.
?
Regards,
Bob
