开云体育

Hi Henk Thanks for the update. I'll take a look at how to speed up the shutdown, it should take no more than 15 secs or so to shutdown the G8JCFSDR completely. For example, if U change the sampling

hello Peter Sorry but i quit the install about the sdr software...i became too much trouble by install the soundcard and the tx mode is not in the g8jcfsdr. Gonna switch too an other system like

Hello Peter i did this without manual changing register and the program still works. one remark I have that when closing the program it stays very long active in the backgound , first as aplication

Thank U Henk for the good news :-) Could U please uninstall the old 282 version from that other PC, and then re-install with 282.6 and make sure all is OK ? Really appreciate the report. Peter

Hello Peter i have tried the 282-6 installer on another pc that did not have previous installation and it works ok on that Pc Regards Henk

okay Peter i shall send it soon as posseble. Berend Op ma 11 jan. 2021 15:08 schreef G8JCF <g8jcfsdr@...>:

Hi Berend Sounds promising :-) Could U take a screenshot of the G8JCFSDR with it running please so that I can see your settings ? 73 Peter - GM8JCF

hello Peter, I have installed 282.6 now but got no spectrum on my schreen...got sound and can change fregency ..so normal layout but no spectrum. thanks anyway for al your work Berend pa0bzc Op zo 10

Hi All It's been an intensive few hours here, but I think I may have the proper solution, ie X32 and X64 compatible Build 282 installer. The release candidate for the latest build 282 installer may be

Hi All After further investigation, it would seem that my version of InstallShield is not 100% compatible with Windows 10 unfortunately and doesn't correctly generate the code to register the

I can confirmn that this new installer doesn't solve the problem either unfortunately. For now the only fix is to install 282, then manually register dx8vb.dll as follows Run cmd.exe As Administrator

Hi Henk Thank you for the report. Bad news :-(? Back to the drawing board 73 Peter

Hello Peter I also did try to run the installer as administrator before rgeistering the dll manually. This did not help regards Henk

Hello Peter ones it was registered manually one time the next time you reinstall 282 after uninstalling it is till registered and 282 will work after installation. Only the first time it has to be

Hello Peter the new installer does not solve the problem with registering the dll, i tried it yet on another computer and also there i had to do it manually as above, sorry for this. regards Henk

Hi All I have updated the installer for G8JCFSDR Build 282 and made it available on the G8JCFSDR site http://www.g8jcf.uk/g8jcfsdr_drt1/downloads/setup_G8JCFSDR_282.exe I have tested the new installer

Thank Henk for letting me know, I am might relieved !!! So now U can try out the higher sampling rates and see more spectrum :-) Thank U for persevering with me to find this problem Peter - GM8JCf

Hello Peter that did it ,thanks regards Henk

Hi Henk I think I've found the problem. When I installed G8JCFSDR Build 282 onto a clean W10 machine, I got the exact same results as you've seen, ie no spectrum although everything looks correct. The

Hi Henk Ah, yes, my partner got a brand new W10 machine for Christmas which has never had the G8JCFSDR installed, so I will try installing the G8JCFSDR on that machine and see what happens - thanks