开云体育

The log file looks OK. What did DXDiag.exe report about your sound card/driver ? 73 Peter - GM8JCF

here's my log file. Running but no sound

wasn't initially in start menu, is now.

in spectrum display, spikes to 10^-6 at 14k 16k and 1k. [email protected]> wrote:

Scope shows essentially nothing, very, very low level random noise. [email protected]> wrote:

So the G8JCFSDr Trace Mode Start-Menu shortcut isn't "C:\Program Files (x86)\G8JCF\G8JCFSDR\G8JCFSDR.exe" /trace" ? 73 Peter - GM8JCf

I have to append /trace to get it. As an exe it doesn't exist here. I did use the install package.

I assume that U have run the G8JCFSDR installer, which would then create a Start Menu entry G8JCF under which U will find G8JCFSDR and under that U will find lots of shortcuts, See above Peter -

What start menu?

Good News :-) If U have installed build 280 or 281, your start menu should contain an entry for "G8JCFSDR Trace Mode". The G8JCFSDR was developed back in 2003, initially under W95 on a 333MHz Celeron

Thank you. My "duhh" moment came with switching to "serial" port. Runs fine now, but still no sign of signal on display. Also, how do I start in TRACE mode? Also, on an older PC running XP, I haven't

Hi Dietmar Your screenshot of the error is unfortunately not enough for me to diagnose the problem Could U please run the G8JCFSDR in TRACE mode, and send me the logfile to g8jcfsdr (at) gmail (dot)

Hello Peter, In the meantime i tried it on another win10 machine. Same Result, the program crashes. Do you think that you find a solution? THX Dietmar Für Fragen stehen wir Ihnen gerne jederzeit zur

Hi Welcome to the group :-) My Arduino UNO also uses a CH340 USB to TTL Serial chip - typical of cheap chinese clones - and I have never had a problem. Since your UNO works correctly with the Arduino

My arduino uno clone uses CH340 ftdi chip.? Does this cause problems with your app???? It works fine with Arduino IDE. Which serial option should I use for USB connection to arduino? I get error

Hi Jean-Marc Build 281 is a beta release, so the protocol to the Arduino is very fluid and constantly subject to change. Currently, the c TargetF ActualF<crlf> message is retained, but I will probably

Hi Dietmar Could U please run the G8JCFSDR in TRACE mode and send me the logfile ? 73s Peter - GM8JCF

Hello Peter, Sorry, same Error…;-( [cid:image001.png@...] Für Fragen stehen wir Ihnen gerne jederzeit zur Verfügung. Mit freundlichem Gru? / kind regards, Dietmar Steiner from

Hi Peter, What is the new Arduino exchange protocol v1.3 for Elektror SDR Shield v2? Best regards. Jean-Marc

Hi I have generated a beta release of the G8JCFSDR V1.0 Build 281, which may be downloaded from http://www.g8jcf.uk/g8jcfsdr_drt1/downloads/setup_G8JCFSDR_281.exe *Release Notes for Elektor SDR Shield