开云体育

The SSB filter does work. When using test equipment it is obvious that a difference has been made when switching the filter in and out. For many operators, the perception of a difference on receive

I am leaving on a business trip this morning. The 817 is packed. I will return this weekend and will reply.

Doug, Like you my ATX walkabout doesn't like being connected to the rear SO- 239, it however tunes up great on the front bnc connector. I don't know why but I am suspecting the Pl-259 elbow

Yes. I've been using it for about 3 months right now. Best DX (SSB, 5 Watts): Holland - Massachusetts. Rene PD1ALD the

Yaesu" FT-817 is in the ball park with others when it comes to RF power out. The following readings were taken using FM mode, dc voltage at 13.6 volts constant and into a 50 ohm load. Dear Don,nice

Whoops! INT OSH (Was that an Operator Short between Headsets? -- grin) Cortland had

Uh... operator error. I looked at the modification instructions again, with the aid of the two photos in the files section. Turns out I had soldered the wrong pads. Three minutes with my smallest

Yesterday I worked FO5RA, Jean from Tahiti. He was ONLY working QRP stations. Took me about 30 min. to finally get through from the West Coast. Wow a QRP DX pile-up. Cool! Anyone else get a

Bob, In the FAQ you can find How do you enter the alignment menu? With the FT-817 turned OFF, press the A, B, and C keys at the same time and turn the power ON. When you enter the first time,

How does one get to the alignment menu? Bob - VE3MPG

power comes out (according to the FT-817's power bars: 0 bars!). On the other hand, my power supply shows about 1 A current. Hi Rene, This may be a dumb question, but are you sure you have TX power

--- In FT817@y..., w4wb@a... wrote: [stuff deleted] > > Rationale discussion is encouraged, but rudness is to be avoided. > > 72/73 de Barry - W4WB > FT817 Group Co-Moderator Hi Barry and

I checked it with 2 SWR/Power meters. On 20 metres, it gives 500 milliwatt (full power selected on FT-817). External 13,8V power supply, no batteries inside. Rene PD1ALD power it suddenly,

Even without the battery pack, the power remains low. On HF, no power comes out (according to the FT-817's power bars: 0 bars!). On the other hand, my power supply shows about 1 A current. Rene

Rene, If you have an internal batery pack installed, try disconnecting it from the 817 and run with the 13.8 V DC supply only. If all is well, you may have a battery problem. Maybe overly

Well said Demetre( and a few others), At last some sanity. Rgds - David

"Mark A. Smith" wrote: I have tested/compared the 17 meter version with my 4 element 17 meter mono-bander. It worked remarkably well! It is a bit of a mystery how Mr. Traffie gets a 50 ohm

I talked with Robert at the phone # listed on the web site. He told me they do use a variable xformer & the rig looks at the primary as the counterpoise. I'm going to wait for the July QST article. I

Rene, I had a similar problem when the internal rechareable battery voltage dropped too low. Extenal 12 V was OK. Recharged the internal battery and the power was OK... Chuck Carpenter, W5USJ,