开云体育

I have to agree. I tried a pair of 20 meter Maldol whips configured as a dipole and fed with coax. It worked but then I tried a 15 meter wire dipole fed with ladder line to a Z11 autotuner. The tuner

What possible value would putting a 12 v pack into the rig have? You can run the rig at full output power by simply connectind a 9.6 V pack into the external power plug. Remember that a fully charged

is fixed easypeasy by David, You are not doing your batteries any good by overcharging David. The charge acceptance factor varies from about 1.2 to 1.6 depending upon brand, initial discharge state,

Lowes carries an Aluminum/Plastic Brief Case for 24.97 and it has removable partitions and pre-punched foam so both or either could be used to store FT-817, MP-1, Z-11 Tuner, Dipole, and key. The

Not trying to sound short here but you just gotta download and read the FAQ's on this page. I print them out whenever updated and they answer all my questions and even some I don't have. Also look at

the

the Pico fuses (mfr: Wickman) are in the Digi-Key catalog (www.digikey.com). There is a possible alternative available from RS (online only) which they list as a subminiature fuse. This is

I don't think you'd get 200mA (actually more like 240-250mA) if you installed a 12V battery internally, as Frank suggested. I think the only solution if anyone tried that would be to add a separate

The charge time can be set from 6 hours to ten hours. The current is fixed at c200 mAh, so 1600 NiMH cells take two ten hour charges. Email me if you need further assistance. (the green wire mod is

Nor me, but roach poles are geat aerial poles. car boot sales let them go for about a fiver each. Come as 5 or 7 metre ones. CAUTION the black ones...carbon fibre!!! David

Try a wire dipole. Cheaper, lighter, easier to pack and better to use David

Of course their is a rule for QRP SSB since long times. All QRP Clubs worldwide accept 10W PEP as SSB QRP Power. As far as I know, the new ARRL QRP DXCC starting Jan 2001 also says 10W PEP to be QRP

Hi! I would be glad to set up a schedule with you so you can remove the virginity on your 817. Email me directly. Shouldn't be a problem to make contact 817 to 817. Paul KB8VWV Charlevoix, MI

I use a steel tape measure connected to the back of the 817 (alligator clip fixed to the earth termonal screw) and extend it to 240cm for 10 metres. No SWR indication. Adjust the top whip section for

How can it work better on RX and not on TX? Both RX and TX are 50 ohm, and so the Q, matching etc. will be the same for both. Julian, G4ILO just not convince the ATX

I'll take your word for it. I know nothing at all about fishing! Julian, G4ILO is the

Bil KD6JUI wrote: The following link answers all your questions: http://groups.yahoo.com/group/hfpack/messagesearch?query=chalkline Bonnie KQ6XA

How about an antenna shootout with an ATX, MP-1, low dipole on fiberglass pole, and anything else truly portable someone's excited enough to bring along? I realize this won't settle a darn thing :)

Some people have posted messages about rolling antenna wire into an empty chalkline reel -- it would make a fine container, and it would make retrieving the wire fast. Today I tried rolling some #22