开云体育

Check allelectronics.com. I've dealt with them for years as a buyer & seller. I just ordered a switching P/S & some split ferrite filters for it. I use a switching P/S with my Scout (I'm selling the

May I add a word of caution about sharing frequency files. Do NOT share your .817 files - these files contain a lot more than just your 200 memories, and are country specific. I suggest you share the

Sounds like the TR relay in the amplifier is not making good contact on the "through" position. Try transmitting through it with the amplifier off to clean the relay contacts. Cortland more, dah has

Dear Group Is anyone interested in sharing frequency files to be used in the FT Basic program? If anyone is interested I have the following contained within a file HF QRP Frequencies. 6m UK Repeater

So if we are going to start putting other stuff on this forum, what's next? CB, auto parts...etc? Confused

Would you two mind emailing each other directly? Lee/k3re

You should investigate implenting this, Bob ... the FT817 manual shows a nice table for working Low Earth orbit (LEO) FM sats. They have you 'tune' for Doppler' by going down a set of sequential

I think Elecraft was taking orders for the interface. Shipment is scheduled for about six weeks as I recall. Thanks for the report! 73... Ed, W5EJ

HRO had FT817's for $669 at Dayton, and most dealers matched their price. All seemed to have a whole lot of them, along with the 1800mAHr Maha battery for the FT817 and charger. They sold the LDG auto

cool Saw it at Dayton...no big deal, just catching up with the Yaesu VX5R out for nearly 3 years. It is not available and won't be available until the fall. Withe 5 watts on 220 it is the reason that

Why?

Hello Duffy, FTBasic does not presently enable you to store 2 frequencies in one of its memories, so you cannot store a cross-band pair. What it does do is to store 1 frequency and an offset, which is

Which dealers were selling the ATX antennas??? I thought those were only available thru UK dealers. I've been considering the Maldol line of antennas as well. Mike - N1EVH n1evh@...

style of a wallwart. YES! It's not as small as a laptop supply ( it is very compact ) but it works well, 2A and excellent regulation. Contact www.tandmelectronics.com for the phone number. It may not

I don't operate CW, but I have the 500 Hz filter... the 300 Hz filter is virtually useless on the digital modes... 73 Jim, VE3XJ undecided

Bob, What I need to do is described in the FT-817 manual on page 77 in the Appendix "Setup of Memories for Low Earth Orbit (LEO) FM Satellite Operation". The VFO A/B workaround you described will not

A problem has developed when using the FT-817 with my Tokyo-Hy-Power 50 Watt HL-50B brick amplifier. In the CW mode there is a sizable time delay, like ten seconds or more, before a full sensitivity

I sold my 500hz filter and bought a 300hz. I like the 300hz better. Really tight. Dave K1EPJ

Check out the new eGroup for Kenwoods new Triband ht! this is a cool little radio with 144, 220 & 440mHz and wideband recieve! http://groups.yahoo.com/group/THF6A

Has anybody found a 2 amp wallwart style supply that works with the 817? I am going crazy looking for a "NON- SWITCHING" supply that is in the style of a wallwart. Thanks everybody, Bill W9WCR