开云体育

Thanks Kevin for the reply. I am trying to find someone that just sells the battery alone. Not the charger or battery plate. I already have that. Just need a smaller battery than the 8 cell one I

If you have not done so yet I would highly recommend just going with the windcamp battery. I’m not sure what you are running but the windcamp has been excellent for me. Works great for my POTA

Ok Martin the battery is a 8 cell 2000mAH. Size is 4 inches x 2 1/2 inches. Takes up the entire compartment. No way will the Wind camp panel I ordered will fit. Dave -- 73's de NU4N

Thanks for the reply Martin. I will open the rig up and get back to you. Dave -- 73's de NU4N

Hi Dave does you have an pictures from the Battery with the technical data? Vy 73 de Martin HB3YDM

Thank you for the quick reply, Bruno. I've used a Vibroplex semi-automatic key and a Lionel (I still have that) so I'm used to dits with the thumb and dahs with the index finger. In this case, though,

A hint about the battery you have would go a long way in getting feedback comparing the physical size of your battery to that of the windcamp battery... Ken, N2VIP

I recently ordered a Wind Camp Battery plate. Seems the battery I have is too large for the plate.?? Dumb question, is the Wind Camp Battery that much small than the battery I? have? I assume

Hi John It’s a matter of preference, i would risk saying that Iambic B is the only mode on the FT817 and also risk saying that it is the most common mode to be using a paddle. The main difference

As a long-term straight key operator trying to get to grips with iambic keying I would like to know whether the 817's internal keyer is mode A or mode B. Whichever it is, there isn't a choice, and I'm

Good morning to the group, take a look at the following site , brandonb.ca has an excellent tutorial on aprs using direwolf on raspberry Pi using the digirig. Vy73, Rick VE1RNM [email protected]>

Not specifically with APRS but with packet.? It was overdriving the input to the radio.? Need to cut the trace inside to reduce the audio. 73, Jeff, KA1DBE

That sounds like a really bad design. The cells do not stay matched and how do you match capacity? Any proper charger for multiple series LiIon cells needs a controller than measures each cell.

https://www.aliexpress.us/item/2251832432748054.html Or search for "aili 18650 powerbank". This is the kind that satisfies the requirements. I haven't tested it for EMI with my FT-817 yet. Using it as

Hello, Does anyone use the Digirig for APRS? How does it work? Daniel PY2TDB.

Hi Dick Thanks for help. I did some search over the internet, but didn't get across this page. One thing that didn't came across my mind yesterday, was that you can calculate new values by multiplying

I have a 12V 24 aH (13.8V 24,000 maH) LiFePo as the largest practical size pack. I have two sets of Anderson Power Poles for 12V gear and two 12V to USB-C plug 5V 3A step-down inverters (for raspberry

Also, note - the power bank you linked to claims 20,000 mA, but at what voltage? I suspect at 3.7 volts, the voltage of the internal cells - 20,000 mA at 3.7 volts will be closer to 5,000 - 6,000 mA

?I’d stick with a 12 volt lifepo4 battery and use converters to power/charge 5 volt usb devices. I recently added the Windcamp battery kit

The connected device controls the output voltage, you would use a cable configured to "tell" the power bank to supply it with 12v. I don't think anything 'guarantees' the power bank won't provide a