开云体育

Following Blasco's advice, today I used a Powerwerx meter: With Bioenno (LIII not blinking but with all 9 bars from PO indicator lit): RX: 0.35 A, 13.06 V, 4.7 W TX: 2.3 A, 12.90 V, 29.6

Michael, The damage that can be done to the FT-8xx series of radios is why Yaesu recommended to the HAM RADIO DELUXE folks to remove the capability to read/write to that same area. The later versions

Check chirp website [email protected]> escribió:

I've seen a price in Europe of 999 euro ......another hop says 9999 euro. It can be ordered for 999 at the specific sellers store. Will be available early 2025 73 Kees PA1CJT Op 12-01-2025 om

Supposed to be coming in February the last I heard. This is, so far, the least publicized radio I have ever seen. 73 Kevin Mullens K5KTM

Hi Dave A google search shows Gigaparts it can be reserved for $35.00 but that is all I see right now. The picture in that ad shows a nice looking rig. Not sure I need another rig right now so I

Anyone know when the new 10 w qrp rig will be available? Thanks Dave -- 73's de NU4N

Anyone heard when the new Yaesu 10 watt radio will be available ? Thanks Dave -- 73's de NU4N

Did you try to measure the power? Regards Lou VK3ALB Regards Lou VK3ALB [email protected]> wrote:

Not quite right. Blinking will only indicate, that voltage is lower, but power will be 5 watts. 73, Andy DC3AFA

This only means the voltage (not power) of your Bioenno battery is not high enough to allow 5W output mode. When a battery voltage is greater than ~ 11.5 volts the 5W output is enabled, when a battery

Hello, If I use a Windcamp 3 Ah battery, I can choose the power among the values LI, LII, LIII and LIII (blinking). If I turn off the windcamp switch and plug in a 9 Ah Bioenno, I can only choose

I finally got the bluetooth CAT device for my 817 and am using Dan Toma’s Pocket TxRx lite after difficulty on an older Android phone. It is a very slick program. Dan gives all sorts of warnings of

Removal of that +Vcc is the final step the sequencer performs when switching to transmit, and the first signal to be output when switching back to receive. Chris Cox,

Definitely does work, Andrew. I do exactly the same on one of my 10GHz rigs. If I remember correctly, I have a ~1k current limiter resistor in series between the +Vcc and the TxInh pin. Chris Cox,

Hi Andrew, I may help here... My radio is FT-817ND and the plan is to use it as an IF rig for a 10 GHz station. Of course, I needed a sequencer and decided to design and make it myself. Using the

Thanks Dave, mine is an original non ND. I recently bought a new finals board, just in case. If you’ve seen the external display, it’s a nice option, but does add some clunkyness to the compact

In my experience of hearing tales of woe (not personal experience) damage to the FT 817 was caused by trying to use a tuner to an unknown antenna for too long of a time. High SWR seems to be the

Mike WA1MAD wrote… In the past, I used an Elecraft T1 auto-tuner and the FT-817 survived that. I recently picked up a manual QRP Z-match tuner with an absorptive bridge, so the radio never sees a

Thanks Keith. The 1.5 watts on AM sounds relatively safe. Not sure how much of the 5 watts max might cause the finals damage. I know there have been reported damage, but I don’t know the actual