开云体育

It was me who said it. Just because you haven't seen it doesn't make it not possible. As i said my ND was an early model (4e serial) perhaps they changed things after that run

Very good. I was pretty much certain the software mod DOES NOT WORK for the FT-817ND. Even though someone said it worked for him, I wasn’t buying it. Glad you got it working. Enjoy. Mike

Fyi, my rig is a '4E' serial number. -- Peter..... (G1FXE)

Thanks to all who responded. I tried the Widebander software mod (Thanks Robin G4JDO) but to no avail. Plucked up the courage & downloaded the Yaesu jumper mod sheet and reset the jumpers and all’s

Apologies for the delay Mike, i have to dig through my software archive to find the answer. The application i used was called 'softjump', this appears to just change a 2 byte value in the rig and it

Go dkmod. They have all the info on this.? Cheers. Owie. ?vkyba@... Sent from Yahoo Mail for iPad

Thanks for all your suggestions. I did wonder about the old uk allocation but thought it was expanded before the nd was released. I’ll let you know when I’ve got it sorted. Probably not

That is interesting…….. I had always thought-heard-been told only the FT-817 could be opened up with software. One of the “improvements” of the FT-817ND was that it took a physical MOD to

FWIW my elderly FT817 needed “expanding” to cover the extended portion of the 40m band, I did mine via the “jumpers” sadly a side effect is losing the ARS functionality. 73 de G0FVT Sent from

Still worth trying a PC/Software based MARS mod, my rig is an early 'ND' model and took a software mod ok. Rgds, Peter..... -- Peter..... (G1FXE)

?Hi Andy, I had the same issue with my 817. You need to open up the band by either soldering some pads in the head (display) assembly or by using software. Soldering the pads is rather tricky due to

Hi Andy – a memory lurking in the back of my mind, didn’t the UK have a reduced 40m allocation at one time? Perhaps this 817 dates from that time and has the reduced band set internally? Just a

It is probably set to the earlier European 40m model, 7.000 to 7.1000. The ND model cannot be programmed externally, you will need to open it up and do the solder modification. Mike – KD5KC

One of my FT817nds (serial no 4H) won’t transmit on the top half of 40m. My other one is fine and this one works on the lower half and on all other frequencies. I’ve just started using this one on

To be sure, look at the numbers on the connector. -- Al Skierkiewicz WB9UVJ

Do need to watch these connector pin-out diagrams.? Once wired a Yaesu mobile rig mic connector for a digital interface and on one side was 5V pin from inside the rig and on opposite side was PTT

Hi Mark I think so, but you may have to use a meter to confirm that. I have looked for a confirmation and never really found a printer form. It has been a lonnnnng time since I have assembled

Steve and Marty, Thank you for your responses. The service manual is a keeper for sure. I found what I needed from the schematic on page 29. It shows the 8-pin Mini DIN configuration and the pin-out

Check the HL45 schematic. It has remote circuitry inside.Sent from my Verizon, Samsung Galaxy smartphone

Speaking of power amplifiers and pinouts, does anyone have any resources for building your own remote for the Tokyo Hy-Power amplifiers? I've had a watch on ebay for going on 4 years to see if an