开云体育

Hello, Does the FT-817 support CW via CAT cable? I'm trying to configure FLRIG, but without success. 73 de PY2ZA

Despite many postings to this list and its yahoo predecessor correcting people, people continue to make incorrect postings about power output and how the 817 displays it. Below is a re-posting on this

Thanks. I finally got out my QRP dummy load wattmeter, which I should have done earlier. What confused me was when the lines are full it's 2.5 watts, then steps down, 1 watt then .5 watt to no lines

What is the cable’s pinout to use for the M0BMN widebander software ? Thx, 73 Ben

Yes, same as with external power. If the power indicator is off, it is full power. It might flash on and off during transmit, but it's still full power out. Half power has two

I am confused on power out with the Windcamp battery setup. Is there a 5 watt setting? Mike WA1MAD <feltusfecit1@...> wrote:

Roger that. I love the Windcamp battery, but find charging it hit or miss, and I have no idea why. [email protected]> wrote:

Sounds to me like the Windcamp BMS doing its job to protect the battery. I am on my second one of these. First one, the BMS isolated the battery on low voltage as I expected however it didn't come up

Hi KA6BPV, I posted a video a few months ago in response to a Youtube viewer who had no TX on 70cms. The 2m VHF and 70cms UHF TX paths are very closely related, so this 70cms video will help you

After some considerable searching I couldn't find any reference, but Geert's comments on /g/ft817/topic/44798483 are helpful. Resetting the radio post mod. seems to be a general

I have a gen 1 FT-817.? Recently replaced the finals board (had very low power on TX all bands).? Incidentally the board is still available from Yaesu for $24.? P/N CB1333004. I thought I had the

HI I'm using my *FT-817* with cat in the *QLOG* log (Linux version). Does anyone use it? Did you manage to configure the *CW* ? 73 de PY2ZA jr

"I did mine via the “jumpers” sadly a side effect is losing the ARS functionality. 73 de G0FVT" I recall reading somewhere that loss of the automatic repeater shift is dependent upon whether or

“Does anybody know if the Japan version of the FT-817ND can be configured to match the US band plan? Serguei VE3KDE” No. Nice try, though.

This mod should get you aligned with the US band plan https://www.iu2frl.it/wp-content/uploads/2017/03/full_tx_on_yaesu_ft-817.pdf Good luck, tom kj5dyu

Hi have a look in the service manual, you can change the links on the back of the display for band plans Dave 2E0DMB [email protected]> wrote:

Does anybody know if the Japan version of the FT-817ND can be configured to match the US band plan? Serguei VE3KDE <on5bgo@...> wrote:

Thanks Nick for the trick. I downloaded his software. But that widely opens the 817, not only the second part of the 40m Band (or the 60m Band). Is there another kind to open just our ham’s bands

Try a search for "M0BMN widebander". That was the software I used to use to unlock coverage for 60 meter operation.

HI all, I am trying to repair an early model FT817. It is fine on all bands/modes in RX.?It is fine on TX in all modes, *except for 18Mhz (17m) and 21Mhz (15m)*. In the affected bands, measured in