¿ªÔÆÌåÓý

And a magnifying lamp.

Thank you very much. Here the same, but a couple of hours after turning it on, the power goes back to normal. I'm not sure I want to spend 130€ for the 2m band only... I'm thinking about a heater?

Hi Neil The main thing is to use plenty of flux, Dave 2E0DMB [email protected]> wrote:

Thanks Dave ¡­ I never had the opportunity or training for SMD work ¡­ well done!

Hi Neil Thanks for the info, Yes it is a big job, but I have done a lot of smd work so I changed the diode myself, Good luck Dave 2E0DMB [email protected]> wrote:

Hello Dave 2EODMB About ?132 - ?90 labour (1.5 hrs) plus ?4.60 for relay plus diode, plus VAT plus ?15 carriage. It¡¯s fiddly stuff ! I¡¯m happy ¡­ your call ¡­ Neil

Hi Neil What did they charge for the repair, Dave 2E0DMB [email protected]> wrote:

Hello from the UK. I have a gen 1 FT817 that I still love. I have just had your problem and it was fixed by Yaesu here in the UK - they take 3 to 4 weeks to repair and always do a fantastic

Yaesu XF-122 C, 500 Hz Collins Mechanical Filter For Sale: I have a Yaesu XF-122 C, 500 Hz Collins Mechanical Filter For Sale. It is sometimes called a YF-122 C. It also has the

Hello, I think I know the answer, but let's see: by the end of the charge (say, 1/5th of estimated battery charge), if I'm TXing SSB or DATA, on 5 W, ALC goes to zero. If I set power to 2.5 W or

The line-level radio "DATA" (really audio) output is almost certainly overdriving the default mic-level input of the DigiRig. The solution is to enable the Digirig's built-in 20db attenuator.

Rod, is your digirig setup in the duplex serial CAT with logic levels configuration? It can be changed after the fact if necessary. The 818 works with that config but I have heard the trusdx can work

I've been experimenting with Winlink on my radios and had success with my little trU(SDX) but cannot Tx/Rx winlink with the FT-818. I have CAT control set up OK as the radio tries to connect with

I just checked the display and yes there is a squarish icon which may actually be a clock that shows just to the left of the L. I guess with my eyesight, I thought it was an square, in place of the L,

Does the L become a square if on auto shutoff? A buddy said it does. I¡¯ll check that soon. Mike Davis WA1MAD

Hello, Does the FT-817 support CW via CAT cable? I'm trying to configure FLRIG, but without success. 73 de PY2ZA

Despite many postings to this list and its yahoo predecessor correcting people, people continue to make incorrect postings about power output and how the 817 displays it. Below is a re-posting on this

Thanks. I finally got out my QRP dummy load wattmeter, which I should have done earlier. What confused me was when the lines are full it's 2.5 watts, then steps down, 1 watt then .5 watt to no lines

What is the cable¡¯s pinout to use for the M0BMN widebander software ? Thx, 73 Ben

Yes, same as with external power. If the power indicator is off, it is full power. It might flash on and off during transmit, but it's still full power out. Half power has two