开云体育

Hi I don't think it is the correct board you neen the final board, Radio world in the united kingdom have stock, have you called yaesu UK, Dave 2E0DMB [email protected]> wrote:

I contacted the company CSY & Son, responsible for Yaesu spare parts in Italy. Currently, only the PA board CB1152005 is available, which is compatible with all 817-818 models. They told me that the

Yaesu, maybe I had a old radio I removed it from Have a look for a equivalent, it's probably nothing special,but as it is on the underside of the board , I would get the correct one or equivalent

Hi, Is there a reliable seller for the HSU277? Regards Lou VK3ALB [email protected]> wrote:

With those symptoms, ?are likely to have an open D3003. It's possible it could be a relay connection or bad solder joint to a coil in the same place. But, D3003 is the usual issue. ?One test is to

Hi This is my post when i found the problem i was having, Hi i found this when my FT817 did not output power on 2m and it was the Diode that had gone bad, Good Luck, Dave 2E0DMB so on Pin 8 of Q3003

Hi if you look up posts from me 2E0DMB you will find the info, I had this problem with a ft817nd and it was a diode On the bottom of the band switching board if I remember correctly This has been

Pietro? I2OIM I have a PDF of the 817 / 817ND? if these would help I can send a copy CharlieKA9HDG

It seems that the FT-818 group is exhausted, so I try here. My 818 has no output on 2 m, while it works on 70cm and HF. The SWR is at maximum, so I think some relay is not closing when it should. Is

As I understand it, the parts they are offering today are FT-818 finals, and they work in FT-817/817nd. This part will be offered by Yaesu as long as they provide support for the FT-818, so likely a

So after the newest information on the finals board, thank you! My 817 is a non ND. Will the replacement board work on a non ND? Has anyone actually replaced the finals board? If so, can it be done at

Mike, That was awesome feedback, most every previous report missed one or more pieces of information. Thank you, that was helpful, Ken, N2VIP

Hi Ken.? Not sure if you were asking me this question, but I ordered the final boards by phone from Yaesu in the US.? I called the Contact Us/Parts number on their website. I don't remember if I

Yeasu releases new Owner's manuals as the externals and user interface change. There've been maybe 5 or more released for the FTdx10 so far. Makes sense as more of the product becomes software

Mike ordered and was shipped a finals board from Yaesu US recently, as noted here - /g/ft817/message/115294 Please, describe exactly what you asked for and who you asked for, for

Yaesu said they were no longer available as of early September 2024. I ordered a board from a place in Germany called funktechnik.

Excellent job Nick, Glad you got it fixed, good for a few years yet. Andy

I got around to completing this repair today. Yaesu sent me a Q9000795 rotary encoder (Alps, appears to be identical to the original one), they also sent me a new knob RA026960B. Total cost including

Pietro, just for a little more info can you take a picture of the display when this is occurring and post it here? -- Al Skierkiewicz WB9UVJ

The finals are only one place that you can lose power. Drivers, Predriver, transformers, and (on mine) one of the power switch transistors to the predriver supply all can cause low power. It is quite