开云体育

Perfect Ron, very useful, many thanks. Noted Roger. In my early days at Philips, I witnessed the effect of a NiCd battery pack being overcharged. The pack's internal wiring insulation melted and the

It is some time since I used Lithium-Ion batteries professionally and I have no idea if Li-Po batteries are different. What I DO remember is you have to be VERY careful charging Li-Ion packs. They

John, Here is one article on charging LiFePO4 batteries.? It is from a company who is probably going to try to sell you a charger, hi, but seems good info. How to charge Lithium Iron Phosphate

I'm following this with interest because, although I don't have exactly the same question as posed above, I am looking for some way to charge the LiPo without using mains AC, i.e. from a 12v dc

I like my little Elecraft, works great, tiny package. Good luck, Jay WB2QQJ

Somebody wanted my ldg z817 tuner more than I. I am looking for a tuner to use with my ft187. Looking for a replacement. Randy ka4nma

Hello. The instructions I got with my kit said you could charge the battery with such a charger. However you had to set up the charger as non- balanced configuration. Being a avid RC Pilot, both

Hmmm – I understand it fully. But then – I have 2 kW of available solar, several experimental panels, run 200w of solar on my off-road camping trailer, and at work I have up to 110 MW (that is

Can't say that I have charged it with anything other than the included charger, but I did email Eric Liu, the WindCamp guy, to ask about using a solar panel and controller. His answer, although not

I had no doubt about the original charger. In my go-kit I have the balanced charger for my 6000mAh LiPo. One like this:

I use the charger that came with the battery Been working fine for at least 5 years Best accessory for the 817 John ve3ips -- Sent with a Palm Pilot. Ve3ips.wordpress.com Radio: it's not just a

I recently received a WLB817 battery with its charger. The instructions say to use only the originale charger? but then also says to use a balanced charger in un-balanced configuration for max

Hi Jim, What I've found so far is using a high quality ($$$) GPSDO is an effective solution for the hardware side of the equation. It ain't cheap. But I can't find the steps or 'change this resistor'

You’re welcome. Best of luck to you, have a great vacation. I’m a retired soldier. Other than visiting family in Europe (I married a German) I am content to keep my vacations within the

No processing. Thanks for the tips. I will try all of this. I have a feeling I might be overdriving the radio. Im using a random 35ft 6" wire with a 9:1 unun. Im trying to get this all set up before I

Rob, I should have made clear I was monitoring ALC on the radio and not Power when I mentioned the bars...re-reading your OP I see you were monitoring the PWR Out...I generally run 2.5W when running

If you are metering RF POWER – you should see a couple of bars. It’s your radio and your $$$$, up to you how much power (heat) you’re willing to go. Transmit time and output power are

Thats very interesting Bill. I will get on PSK Reporter and see if I can see myself. I did discover yesterday the slider on the right and turned it up so I showed full power output on the 817. I made

PS. If you read the discription in your linked ad, it states the Cat jack is for use on the FT-857 AND FT-897 ONLY. Not the FT-817. You will have to use a different interface to connect the 817 to

Hello, Yes I have and use one. It is nothing more than an adapter to allow you to use either a Dynamic mic or a electrolytic type. You set it up for the type of mic via a jumper inside. It either