开云体育

You need to add a resistor in the PP adaptor to guarantee that the radio knows it is not connected to external power. If the radio thinks it is on external power, the CPU stays running to keep the

I too run my 818 from my Astron 50M but if the radio is going to be dormant then I use the Windcamp door panel to turn the internal battery off. My YEasu handhelds too seem to have some minor current

Pro Audio Engineering distributes the Kx33 power supply in Europe through Waters & Stanton ( https://www.hamradiostore.co.uk/brand/pro-audio/ ) in the UK, and Lutz Electronics (

Hi! The PAE Kx33 is a constant voltage (CV) power supply and works perfectly when charging the internal battery using the built-in FT-817/818 charger. Cheers & 73, Howie / WA4PSC Pro Audio

Hello,will it charge the battery as well?? Also I am in Europe is there a distributor?

I leave it in the radio, but I unplug it when I'm not using it. Zack W9SZ

I personally remove if storing for more than 2 weeks. At 1 point I needed it and it had leaked to zero. I could only get it to power and charge by installing the alkaline pack to reboot it. Scott

Hi Folks I have an FT817ND with the upgraded battery pack (SBR-32MH 1900Mah), which I use /P but normally with an external Li On battery pack.? I know that there has been much discussion about

Hi Ken, Surprisingly, *just the transformer* for a true 4 A 14 V linear supply weighs in over 3 lbs and is larger than the entire PAE Kx33 supply including AC mains cable, weighing in at less than 1

By "Old style" I assume you mean a linear power supply... "Clean" switching power supplies are available, but at such low current levels (5 amps in this example), a linear power supply would be small

Pay attention to the noise that a power supply can generate, especially if you want work in HF. The better choice is a old style power supply, not a switching one. The important thing is always the

Another option is to get the PAE Kx33 Low-RFI supply...many hundreds of FT owners have taken advantage of the special group pricing for the Kx33 and adapter here. (

Yes that supply will power the FT818 well 73, ron, n9ee/r Ron Wright, N9EE/RHernando Co ARES EC Spring Hill, Florida also n9ee55@...

That supply will be fine for the 818. One thing to think about is the output connections. That supply is more of a "bench supply" and you will have to build a cable to get power to the 818. Are you

Yes

Hello, I have a FT818 and I would to power it with a power supply that has the output of DC13.8 with the current of 5A.? Will it be

I decided to perform the most basic alignment on the 817ND and set the bias on the PA block. I started from scratch and got them on spec, at 37.5mA each, 75mA total. The harmonic is still present but

I've purchased Icom and Yaesu CAT cables from him. All excellent performers.? Maybe a bit more expensive than other choices but I only had to buy once to get what I needed. Take care, MarkAA3K?

Hi Larry We're are you, Have you looked at the menu and done a full reset Thanks Dave

Larry, I use the Yaesu Factory Service Center in California. I just sent an FT-897D to them for repair/replacement of a zebra screen. The other two times I've used them they were reasonably quick, had