If the microphone PTT line is a pull down to ground or some
such function, you might be able to tie that line high. If there's anything on
the rear panel which serves the same function a similar method might be used
there as well. Just a thought without a diagram in front of me.
?
Sonny N1KHB
?
?
?
In a message dated 11/12/2016 1:43:45 P.M. Eastern Standard Time,
FT817@... writes:
I want to connect a receive only loop antenna and don't want to risk
killing it if the 817 goes into transmit. Is there a way to inhibit the TX
output. I could remove the mic so that the PTT is not available but I'd like
something a bit more sure than that. Wellbrook loops are very expensive to
replace!
