¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Felderownersgroup
  2. Topics

Adjusting AD951 jointer fence squareness

 

All

My current fence setting is very slightly off and when I tried to follow the instructions to adjust the zero-degree setting for the fence, I discovered that I was already at the end of the travel, which meant the the bolt that's used as a stop has no effect.? I was curious if there is some other way I can adjust the zero setting of the fence?

Thanks
Anil
 

Just wondering if folks had any ideas about this.? Basically, I can't seem to tweak the last half a degree or so.

Anil
 

¿ªÔÆÌåÓý

Can u grind down the bolt to reach target?

martin/campshure/co/llc
mac campshure
7412 elmwood ave.
middleton, wi 53562-3106
608-332-2330?cell

Designing and building for 50 years


On Feb 19, 2024, at 3:00?PM, Anil <anil00@...> wrote:

?Just wondering if folks had any ideas about this.? Basically, I can't seem to tweak the last half a degree or so.

Anil

 

¿ªÔÆÌåÓý

Hi Anil,

I did not respond as I have a diff model. I had following thoughts based upon dual 51, may not be very useful.

First, are you missing a bolt to set the fence stop.
image0.jpeg

As for the pin and slot. Can you loosen the bolts holding the side (with slot) and move it a little before retightening to get you the 1/2 deg?

Imran Malik

On Feb 19, 2024, at 4:00?PM, Anil <anil00@...> wrote:

?Just wondering if folks had any ideas about this.? Basically, I can't seem to tweak the last half a degree or so.

Anil

 

Thanks Imran, I did not realize I was missing a bolt!? Though in this case, the lack of bolt might not be affecting the zero position.? And I will check out the other idea of loosening the side bolts, I did not think of that.

Anil

1 - 5 of 5