开云体育

All, I have set up a dry run for my first glue up and... This test run is crappy 1x4 DF out of the lumber yard planned to 5/8" < the actually material I am useing is 1/2" KD clr pine. In my little

fwiw, I didn't say the weight was uniform, just "continuous", though I drew it uniform.? ?But the difference between uniform and continuous is moot.? I was just trying to make the point that for

Well, it took about 90 minutes and a few phone calls but I did get the capacitors changed out on my Phase Perfect 20hp converter. I went forward with the change out because Martin Woodworking was

Thanks Mark. The weight of the rail is uniform but the opposite to the hinge stile weight is at the end of the rail, correct. Isn’t glue flexible to some extent? So my thought was that a pin will

Imran, Sorry, I shouldn't have said "loose tenon".? I meant not-glued.? ?My question was are you planning to glue the mortise and tenons, or not glue.? If you're gluing, then pins (or cross bolts)

Thank you Scott & Imran, I know as much about electricity as Fred Flintstone so all information is a great help. My thoughts are that as the brake board is definitely stuffed, then start there and

Trevor, Is there a current sense/limit function in your machine? My KF700 has one but cannot recall if it is part of relay or a separate device. I remember it being same size as the relays used by

When I had my C3-31, it stopped working completely, and it ended up being the braking board.? I ordered the board directly from the manufacturer Klinger & Born in Germany for around 41 Euros plus

Mark, When I mentioned pining, I meant a dowel/peg through the stile into the tenon. My plan has been to build with floating tenons but I could make actual tenons as well. I understand and agree with

I recently posted about my C3-31 stopping during sawing. It turned out that it wasn't capacitors as first thought, but a problem at the electrical distribution board. The machine has been running fine

Discussion of pins confuses me.? Imran, can you please clarify -- are you planning loose (unglued) mortise and tenon joints, or glued joints?

Cool trick Mac. Alex, no worries on thread. Mark T, Great feedback, I will study and reply later. Imran

martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com instagram.com/maccampshure/ Designing and building for 50

Imran, The purely written descriptions a little hard to follow clearly.? I think this is what you mean: Below pic shows crushing in a failed tenon.? I'm not sure what your concern about crushing

I personally think poly iso insulation is a waste. loss of structure and little insulation gain. I used to manufacture doors in 70’s and made poly iso panels they worked fine but gain wasn't worth

Mac, Cross dowels, similar to doweling a bread board end on a table? Pin through the stile and the tenon of the rail? Jonathan, The plan, at this point, is to laminate the inner and outer 1/2” birch

Could you sneak in a full panel of plywood.? It might be stronger than a single stick.? 1/4" thick could even work if it was kept from bulging by the outer layers of the door panels.? Or, replace

I now have the Northfield off a giant pallet and on skids in the shop.? Oddly there is no obvious lift point on the Northfield and nothing in the manual about a lift point.? I now have the 32"

More like email notification. I don’t recall if I ever signed up but likely happened when I inquired about a saw he had many yrs ago. He said he routinely ships to USA. Check the voltage to be sure

Thanks! What is the newsletter? [email protected]> wrote: