开云体育

Yes the sander has cut down on my sanding time for detailed surfaces like crown. it all depends on the pad you use though as the 1/2” sponges wear rather quickly and cut through the surface on sharp

Thank you David!

Edited Message John, Yes. Have a look here: https://flic.kr/p/UHeKwh? Felder "spare part" P-channel mounting block. flic.kr And here. This shows the Felder part number. https://flic.kr/p/23k4ey5?

Be advised - the Aigner overhead mounting bar system for the pressure modules comes in three difference configurations. One is specific to the integral fence, the other two are specific to the

John, Yes. Have a look here (click image for description): https://www.flickr.com/photos/davidpbest/34597211136/in/album-72157679368916583 More information about Aigner pressure wheels and support

Do you need a special mounting bracket to mount the aigner pressure module to the x-roll?

The picture of the Aigner mounting bracket did not make it, let’s try again Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

2nd Brett on Pressure Modules. I use them often and am using them right now for Stiles and rails. I just switched the 2-wheeler out and put the single wheel in because for narrow stock 2 wheels were

Agree with Joe Calhoon. I have resisted spending money on Aigner items only to find how handy they were later. My filler bar (catalog page 50-51)and the "spreader" (catalog page 52-53) get used a lot

It just calibrates the manufactured leg amplitude to match the other two phases. Ron

John, I would still check that to make sure the manufactured leg is connected to L2.

Thanks, Ron. -- John Hinman Boise ID Kappa 450X and A941

I just went through this with Phase Perfect. ?The adjustment is only to balance the manufactured leg. ?I didn’t understand this until their tech explained it to me. ?Only one phase is

Bryce, thanks for the offer. I am not yet convinced that is the cause of my problem, but if that changes I will get back to you. What brand and model is your transformer? -- John Hinman Boise ID Kappa

Netanel, that is one of the things the tech checked, and changed. He modified something in the electrical box rather than changing the plug connection. I am not sure he documented his change. -- John

In the EU, motor plates tend to all be rated 230v for low voltage. Some countries ( France ) run 220 and some ( UK ) 240 so designing for 230 allows the same motors to be sold ( even though no grid

You need something there whenever running thin material. The Aigner fill strip has a couple small hex screws you can adjust against the cast table to keep it from sliding or moving when pressure is

Hi all Aigner Fencer users, I am about to order the Aigner Fence and was wondering about the accessories such as the filler strip. From what I understand, this piece is simply wedged into place by

Yes, it was a comment to David (Dave) kumm

I assume you are directing that to Dave Kumm? I ask because this is a debate I’d rather watch than participate in. LOL David Best