开云体育

Sorry for the delayed response! The ShopSabre is a fully loaded 23 (30"x40"). ?Indexing lathe option, OptiLaser with quick connect dock, 2KW Italian Spindle, 3D copy probe, etc. I will definitely

Check you safety switches. They might be causing the motor not receiving power. Check emo stops as well as latches on shaper belt hatch/saw slide. It should be halfway between up and down. Kind

I am selling my 2023 Felder K 700 sliding table saw that is in exceptional condition. ?I ordered it new from Felder DE and have sparingly used it in my home shop in Wyomissing PA (Eastern PA). ?I

Well, if you have a multimeter it's time to see if power is actually making it to the motor. You may have relays that aren't working or ??? Did this machine run previously, or is this something new to

Thanks for replying. Switched L1 & L2 to no avail

Sounds like you may have the wiring wrong. Try switching the leads. Brian Lambblamb11@...

Hi, I have a Hammer c3 31 3ph, attempting to run from transwave mt5 rotary converter. Other 3ph machines run, but not the C3. A dc brake hum occurs when start us switched. Any suggestions or pointers

Apparently I have a later model of the guard on mine (see picture).? However, it is a very simple construction: the spring needs to develop enough pressure to push the guard up and you adjust the

Like David Best, I made a plywood platform with supports underneath which allows me to move my 16" North State with a small pallet jack. I did try a mobile base, but the problem is that there isn't a

I have not used my FMT or the super Jig since I've moved to Tucson. I suppose my woodworking is going in a different direction. I would like offers on both or either one separately. Thanks Bill

A pallet jack with narrower forks can move around machines on plywood platforms.? I had a 13" wide belt on one, about 1200 lbs.? Not as good as having 4 wheels for tight space but it takes a lot of

I used to keep tools and a workbench on these steel ball casters. These have a 1” diameter steel ball in a cup with smaller ball bearings inside the cup. They roll in any direction. I could

I have mine on a plywood platform with 4x4 feet so I can move it around with a pallet jack that stores under the J/P when not in use. David Best DBestWorkshop@...

I have a North State 16" wide belt sander arriving next week and I want it to be mobile in my shop.? The sales guy I ordered from said that some guys on FOG had good recommendations on what to use to

In my fs52es Aigner rail install we noted that the walls were not parallel or even plumb due to the need for a casting to come out of a cast cleanly. The taper was accounted for by some m8 steel

I just made up an album in the photos section showing most of the items for sale. It is under: ? Felder etc items for sale from john Ormsby Thanks

On 11 May 2025 19:24, "Brent via groups.io" <dovetailtimber@...> wrote: Hi Marty, is that post private meaning others can't see it? I'm still figuring out this forum interface. This

Brent, it's to the entire group as far as I can tell. [email protected]> wrote:

Hi Marty, is that post private meaning others can't see it?? I'm still figuring out this forum interface. B

Eddie canola oil is an and bad choice. It’s sticky stinks online has a low flashpoint or a smoke point. Safflower on other hand has a smoke point of about 450f not sticky and no smell it is refined