开云体育

Glad it's working for you. I only had pictures to go by and it looked like that flange around the top would hit the belt cover on the motor. Brian Lambblamb11@...

HI Dan, That was what i thought initially but when i check it with a straight edge, the castings were machined spot on. It does end up spot on though after a good clean up, it's just that sometimes it

Jup it clears everything. Been working great for the past few weeks. I my case i added a slight bend forwards because if have to clear a homemade throughput for an extra on off switch on my sliding

Does that clear everything? Pictures I have from Tom look like it wouldn't on the side closest to the blade. I had to remove the bolt on that side completely. Brian

Dan, a service ticket is most likely needed as I have the same machine and cannot locate any type of mechanism/bolt/nut or adjustment means.? Out of curiosity, is the turqouise colored device some

Not to be a killjoy but i recently designed the same: https://www.printables.com/model/1250208-hammer-c3k3-hose-connection

Hello Nentanel, Thanks for offering to organise getting a batch of these made up can you please put me down for a kit for two machines please. Hopefully you get enough interest in this project. Just

Hi Brian Since I live in Europe buying a printed model is off the radar. Are you willing to sell the stl and/or fusion file? Regards Bram Baert Op wo 2 apr 2025, 02:14 schreef Brian Lamb via

Bryce, it almost seems as if the attachment mechanism doesn’t retract enough to pull it tight or the surfaces were not machined properly. Could Also be a defective fence plate. I’m putting in a

Unfortunately an aigner fence is just not in the budget at this point. I’d rather upgrade the machine to a format 4 shaper than invest more into this model.

Felder BF6-26 Located 10 miles North of Boston. I can provide lots of pictures if there is any interest. #forsale

Isn't it just an excuse to get an Aigner fence? ? On mine the previous owner had added some packing tape to make everything coplanar -Karl

Thanks, Mike D! Some folks in this group have mentioned issues with getting things clean and screws torqued correctly. Definitely prudent to check YouTube. -- John Hinman Boise ID Kappa 450X and

Straight knife, the scallops are at a right angle to the material passing through the machine spiral heads the scallops are running linearly with the board martin/campshure/co/llc mac campshure 7412

I worked with fellow FOGer Tom Fulmer on fine tuning the 3D printed dust chute adapter for the Hammer machines. After quite a few iterations I have a solution that actually works. Hopefull nobody

John:I recently completed rotating the cutters on my AD951… quite straightforward and completed in a couple hours. Watch YouTube videos, have your tools ready and develop a flow to the process. I

Thanks Rohit, Indeed it looks like you can have multiple sections of tape. I'm not sure i want to be going through that procedure though each time i move from the first part of the tape to the second,

Bryce, Glad you shared, because as I said, I would not have even tried. Imran Malik IAM Wood Creations https://www.facebook.com/groups/362481112015700/?ref=share

Aaron, You are right, I should have prefaced that statement with “In General”. It was a response I copied from a thread on my FB group and sometimes they are not perfectly phrased. The issue with

I’m running a Ridge Carbide brand blade model, TS21248-A with 30mm pinholes. It performs very similar to the characteristics that Aaron described as well. But It’s a +20 rake, and is HORRIBLE