开云体育

Does anyone have a ladder diagram for the motor control for the KF700 S?? I have the schematic that came with the saw, which is helpful, but also somewhat confusing.? A ladder diagram would be so

When you guys say "seal", what is the material?? I'm picturing Costco.? Is that what you are describing?

Z Shadow Bead Aluminum STR-063-063 5/8" W x 5/8" D x 10' Lg. Prime Painted drywalltrims.com Mariusz, This is one style I’ve used numerous times also just a butt line with a steel profile the z

OK, I uploaded another version that's .25mm thicker, it's called the Felder spinter block 37mm wide. Brian Lambblamb11@...

This place has what you need, I used to use their Z-clips for hanging items a lot. Easy Panel System - Monarch Metal Inc. | | | | | | | | | | | Easy Panel System Offers panel fabricators

Measure your stop blocks, mine are 37mm wide off the fence and my printed part came out about 36.75mm, so I'll add the .25mm to the model and repost the stl file. Better to be slightly wider and sand

Thank you Cornelius! Framework is all metal studs (every 40cm on center). I thought about using standard wallboard thickness of 12.5mm, so I would probably order either 12mm or 13mm plywood, unless

David, Another idea for concrete floors. I’ve seen it done many times and looks great. Honed concrete is a smooth, matte concrete finish achieved by grinding the surface, often followed by

Thanks Brian! I will give it a whirl and report back on it. Jason Jason Holtz J. Holtz Furniture www.jholtz.com 3307 Snelling Ave. South Minneapolis, MN 55406 612 432-2765

Hi Mariusz, I usually finish such a drywall edge with a j-bead and then mount the plywood next to the already finished edge. No way (and no point really) of hiding a joint between two such vastly

This has nothing to do with Felder, but I hope some of you might have suggestions. I plan to use veneered plywood on a section of the ceiling in my house, however I have no idea how to treat the

Hi David, I too built my 2400SF shop with the intent of using part of it for automotive and metal work. I installed a two post lift with a 13,000lb capacity. I was a heavy equipment mechanic,

Thank you Imran. Let me know if there's anything I can provide. [email protected]> wrote:

Hi Kevin, et al, Most likely it will work but the writeup will need to be updated for Hammer. I am happy to do that if someone provides pictures and needed details. The main difference is that the

The following items have been added to the Files area of the [email protected] group. * /3D Printer Files/Felder splinter block.stl (

I guess it would have been easier for me to include the link.... duh! /g/felderownersgroup/files/3D%20Printer%20Files/Felder%20splinter%20block.stl Brian

Hi Jason, Sorry it took so long, had to find mine and then blue print it and make the stl file. I did not test print it, and depending on how accurate your 3D print is, you might have to make

David, I have been considering epoxy to? cover my 20 year old stained concrete floor.? It's getting pretty bad.? ?I did not know vinyl tile was a less expensive option.? Is that cost comparison

Jason - Tambours would solve the problem. They were early on ruled out due to budget constraints, but I should take another look. Thanks! [email protected]> wrote: -- Brett Wissel Saint Louis

Hey Brett, I think tambour doors is your solution. I suspect the weight of a bifold door on the flipper hardware will be problematic. You can make the tambour look like a solid slab when closed but it