开云体育

What a thread. I have to admit that I learned more in these few days than in all the months that I dedicated to research. Everyone, please accept my sincere gratitude. After weighing all the

Is the difference in finish really noticeable? I mainly do cabinet shop work with trending materials (at the moment a lot of white oak and hard maple) also how is a 3hp cyclone with a 60 gallon bin is

Hi, I would be interested in the retrofit kit. Elwin

I have myself, and know others (shipwrights mostly) who have used just 2 carbide in conjunction with 2 dull HSS knives to perform surfacing and thicknessing rough Teak. I also know people who

What is your take about using only 2 real Tersa blades and 2 dummy blanks?

Hi JDhm Here is a video of 1 knife change on tersa head, casually done in 26 secs. David is generous. A typical knife change takes me 2 mins. Add another min if you start in planer mode. The knives

JDhm, I have the Tersa knives mostly because the Xylent head was not an option when I purchased the machine in 2007.? I have used the M42 knives since 2007 and they keep an edge longer than I

AFTER, I got my FS41ES with the Xylent head I was having a discussion with Bryan from 360 degree machinery ( a GREAT source for this machine) and he agreed with David Best. I've not yet had to change

There are three grades of knives for the Tersa: HSS, M4, and Carbide. You can use any of them with any wood, but they each have different qualities with respect to edge durability and the resulting

Hello FOG, As some of you are aware, there is a known issue with the Felder short (1100mm) Xcut fence—it does not consistently register at 90 degrees and for many users requires recalibration each

Thank you this is helpful- FS41ES it is then. Now the questions is the Tersa head vs the Xylent. I was set on the Tersa until I realized I'll need to change blades with different types of wood? from

Thank you David for confirming the 1100 outrigger was updated for better registration. I am going from memory but it looked very likely that on this used KF700, it was not something that the previous

We have two PM2800B in the shop and both of them have needed transmissions replaced in the first year. One of them also developed chuck incontinence. I don't know if this model is extra special or we

? Imran, the 1100 outrigger for the X-Roll sliders (K500/700) was upgraded to have the newer 90-degree registration stop. The older version lacked this design. I can’t answer your question as

? As far as I know, this is still true on the 700-series. The smaller non-S chassis does not have a long enough outrigger support arm to allow the full 96” of travel. The max slider length on

?Aaron, my statement about 800mm rip fence version still allowing crosscut to the center of a the long edge of a 4x8 panel only applies to machines without the overhead guard support mast or

Yes please message me with payment details 313-949-8314 B+ [email protected]> wrote:

I'll pay 100 plus the shipping. Marlowe McGraw [email protected]> wrote:

Brad, are you still interested? Thanks -Joe

Just saw you had an earlier offer. If it falls through, please let me kno. [email protected]> wrote: