开云体育

I did quite a bit of reading a while back, and ended up concluding that the FS41ES was the machine to get.? It seemed like the general opinion was that it was a better engineering combo machine.? Up

Resuscitating an old thread: I could understand wye 3-phase equipment requiring a neutral, as that produces a nice symmetrical arrangement and also (as I naively understand it) provides easy handling

Yes…true, but there are also features of the SCM that are better than the Felder such as: 1.) no need to flip dust shoot from Right hand to Left hand with the SCM. 2.) no need to lower the planer

Imran, I can confirm another 700 series fence with that annoying small amount of slop. Spent many hours thinking how to introduce a fixed DRO successfully and haven't come up with a fixed solution. My

I'm leaning toward the Fs41ES for a couple reasons: A. Cheaper B. Can be picked up locally in LA. C. Both machines are probably going to be. overkill for my use, but I like the power height adjustment

Thank you to Jonathan for the kind offer, I'll message you privately to organise. Thank you also to Brian and to Craig for all your help! Davide

Thanks Bryce. Good to know. Would be nice to not have to check square every time when using xcut fence for cross profiling. Imran Malik IAM Wood

That's great Imran, I did check my shaper hood at work today, and there is also some play in mine, so at least you needn't feel like you're the only one! :) Sounds like you're sorting it out

Since I only remove the shaper hood when putting on the bowmouldmaster and in future maybe a tenoning hood I thought I check if shim-ing the micro adjust pin holes would help. I greatly reduced the

I feel pretty frugal about buying cheap watches ( as car #7 comes tomorrow ). Guys don't shop often, but when we do it's impressive. Dave ________________________________ Sent: Sunday, March 23,

Did not think of it but the 45 degrees has a similar stop. See pics. This also accessible from the blade area: Imran Malik IAM Wood

Hi Vlad, I assume you machine is same as mine. The pic below show the stop for 0 degrees. You may need to adjust this or look for saw dust accumulation preventing saw aggregate from traveling fully to

David, I’ve been awhile getting back to this. I finally have an opportunity to work on my dust collection system again, so here are a few answers to your questions, as well as a few new followup

yes, I received the full package, thank you very much, I will have another question about the angle of inclination, for some reason it is very difficult to reach zero, and this does not always happen,

Vlad, You are welcome. BTW, have you checked the pouch attached to the inside of the electrical cabinet cover? The copy I have on hand was scanned at high resolution, therefore I sent only one sheet.

thank you very much, I am so grateful to you, for me my saw is the heart of the workshop

Hi Vlad, Here is the schematic page for requested. Imran Malik IAM Wood Creations https://www.facebook.com/groups/362481112015700/?ref=share

Vlad, I responded to your private FOG msg. It appears you received it but you want another section. I will reply to that email with the appropriate schematic sheet. Imran Malik IAM Wood

Dude. I’m jealous. I wish I could find such a great bargain on a reliable dovetailer. The northeast is a barren wasteland when it comes to used equipment. [email protected]> wrote:

My name is Vlad, where did you send the diagram?